Tips for splitting a prop

Need technical Q/A then you're in the right place

Moderator: martauto

Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Thu Dec 22, 2011 1:30 pm

Proper dumbass question this but i'm getting cheesed off now............

Need to change the center bearing on my prop while it's out of the car but i just can't get the prop to split, do they have a tendancy to seize?

I've got the collar nut undone, it's had WD sprayed down the splines last week in a hope that would soak in a losen it a littlebut it's still not budging!
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Thu Dec 22, 2011 2:16 pm

That's no bother, it's still got the original markings on it.

As far is i understand, you just undo the collar nut and they slide apart but this seems pretty well stuck.
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
maf260
E30 Zone Regular
E30 Zone Regular
Posts: 844
Joined: Mon Oct 01, 2007 11:00 pm

Post Thu Dec 22, 2011 2:36 pm

I may be confusing this prop with one from another car, but have a look to see if there's a circlip buried in there somewhere...
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Thu Dec 22, 2011 2:40 pm

There's one that secures the bearing but that shouldn't stop the prop splitting, have undo that already incase though.
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
User avatar
gooner1
Out humping Reindeer
Posts: 13280
Joined: Fri Apr 14, 2006 11:00 pm
Location: Northampton.For my sins.

Post Thu Dec 22, 2011 2:59 pm

http://www.realoem.com/bmw/showparts.do ... g=26&fg=10


Not sure if this helps mate but can't do any harm.
Image
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Thu Dec 22, 2011 3:11 pm

Just kinda confirms it is just seized in place i think Rob, i've had heat on it a couple of times and have now left it stood up with a load of WD in a hope it can soak down the splines. Need a new collar nut now though as i never realised they had plastic inside them :roll:
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
DanThe
E30 Zone Team Member
E30 Zone Team Member
Posts: 28649
Joined: Sat Sep 10, 2005 11:00 pm
Location: Staffs

Post Thu Dec 22, 2011 5:41 pm

Do you have a well fixed vice? You can put one end in the vice and with a foot on the vice give it a good tugging.. 8O