i recently changed the engine over in my m42 powered chromie rally car and now im having trouble with the heater.
it wont blow any hot air when driving but will when it's been sitting at idle for a while.
i've bled it until i'm blue in the face, both on the flat and with the nose of the car as high in the air as i can get it.
ideas?
i'm going to try flushing the heater matrix out, is there any procedure for this or do i just stick a hose pipe in the inlet side and see what comes out the other side?
no heater after engine swap
Moderator: martauto
-
alan1272
- E30 Zone Regular

- Posts: 414
- Joined: Sat Mar 04, 2006 11:00 pm
- Location: dyserth, north wales
-
Rav335uk
- E30 Zone Meets/Events Team

- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
Hoses connected the right way round??

If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
-
alan1272
- E30 Zone Regular

- Posts: 414
- Joined: Sat Mar 04, 2006 11:00 pm
- Location: dyserth, north wales
-
Curr946
- E30 Zone Regular

- Posts: 425
- Joined: Tue Dec 23, 2008 11:00 pm
- Location: Inverkeithing Fife
as above make sure the pipe from the rear of the block goes to the bottom pipe on the heaterRav335uk wrote:Hoses connected the right way round??
If your wife must learn to drive, don't stand in her way!
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Classic symptom of pipes the wrong way around, so double check!
-
alan1272
- E30 Zone Regular

- Posts: 414
- Joined: Sat Mar 04, 2006 11:00 pm
- Location: dyserth, north wales
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
You can damage the electric heater valve, but most survive.

