Working through the to do list on the cabby and remember that the mot man had an advisory last year that one of the CV boots is split, rear drivers side.
Its a 325 so has rear disks etc.
How do you go about replacing it. As always fearing that what looks like a simple job is going to be a total c**t to do.
Split CV Boot
Moderator: martauto
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Anyone?
-
markgE30
- E30 Zone Newbie

- Posts: 134
- Joined: Wed Feb 02, 2011 11:00 pm
- Location: falkirk scotland
big nut on the hub either a 30 or 32 and the six bolts on the diff.take the big bolt off first so you can lock it in gear then the 6 allan bolts on the diff and the drive shaft will come off.hope this helped. Mark
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Unbolt the shaft at the diff end, drop it down, and prise off the cap that completely covers the end.
This will expose a circlip that holds the shaft into the joint. Remove this, and the shaft can be tapped out of the joint, allowing access to both boots.
This will expose a circlip that holds the shaft into the joint. Remove this, and the shaft can be tapped out of the joint, allowing access to both boots.
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Thank you both, Sounds a little complicated. I'll most likely be making a start to this at the weekend so will more than likely be back with more questions.
