Hi there,
I am a new owner of a 320i cabriolet. When the roof is down it looks as if there should be a plastic panel at the back of the interior rear panel to cover a hole on each side where the steel roof mechanism sits. Hole is approx 2 or 3 inches square. It is immediately in front of the horseshoe on each side, but in the interior panel NOT the horseshoe. I have looked in the on-line catalogue but can't see if it exists. There do seem to be the remnants of some clips there, so I am guessing they should be there. I am wondering if they clip in only when the roof is stowed away? Any help on identifying them would be gratefully received!!
Many thanks,
MarkS100
Convertible - plastic trim panel question
Moderator: martauto
-
andyp
- True Old Skooler
- Posts: 6899
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: LONDON
hi and welcome to the zone,
yes you are right there should be a square-ish plastic flap each side with a spring lid
yes you are right there should be a square-ish plastic flap each side with a spring lid
Last edited by andyp on Fri Dec 02, 2011 5:01 pm, edited 1 time in total.
-
Gert_8
- Married to the E30 Zone

- Posts: 11302
- Joined: Mon Dec 08, 2008 11:00 pm
- Location: In your back passage faster than a rat up a drainpipe!
Hello. Welcome. If they are missing you'll probably be able to get replacements from somone breaking a cab on here. easy to fit. Car looks annoying without them, doesn't it?!

PONY, 2013 - "Anyway span 360 degrees hitting the kerb and giving the old man two fingers as I was spinning like Michael Schumacher would
-
MarkS100
- E30 Zone Newbie

- Posts: 21
- Joined: Mon Oct 10, 2011 11:00 pm
Great - many thanks, I can understand why a spring lid would work here. Now I just have to get hold of a couple!
-
andyp
- True Old Skooler
- Posts: 6899
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: LONDON
i dont think they are much to buy new from the dealers.
