LOSS OF POWER ABOVE 2000RPM

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
GAZZANATOR
E30 Zone Newbie
E30 Zone Newbie
Posts: 63
Joined: Sat Nov 28, 2009 11:00 pm
Location: Glasgow,Scotland

Post Wed Nov 30, 2011 11:51 pm

WAS DRIVING ALONG TONITE IN MY 320I AUTO IN THE RAIN AT 30MPH,AND WHEN I PUT MY FOOT DOWN TO SPEED UP THE CAR WOULDN'T RESPOND,AND WHEN I EASED OFF AND PRESSSED THE ACCELERATOR AGAIN THE CAR BUNNY HOPPED FOR ABOUT 20 YARDS AND I HAD TO COME OFF THE POWER AGAIN,BUT IT CARRIED ON BELOW 2000 RPM WITH NO PROBS.WHEN I STOPPED THE CAR,I PUT IT IN 'N' AHD REVVED A LITTLE WITH NO PROBLEMS.DOES ANYONE HAVE ANY IDEA WHAT MIGHT BE CAUSING THIS ? IT FELT LIKE FUEL STARVATION,BUT AS I SAID IT REVVED FREELY IN NEUTRAL.
mrLEE30
E30 Zone Team Member
E30 Zone Team Member
Posts: 6589
Joined: Tue Jan 18, 2005 11:00 pm
Location: Sweating buckets in Bahrain

Post Thu Dec 01, 2011 5:19 am

firstly dont use captial letters, in internat land it is considered shouting and thus rude!!

lift your rear seat lower bench cover and have a drive, a loud whine/buzzing noise that varies in pitch as you accellerate is an indication that fuel pump is failing. also check the vacuum hose to the fuel pressure regulator (located next to the diagnostic plug at front of inlet manifold)

if all good or quiet then check the HT leads are all good (no cracks/perished areas is the first check, a multimeter is the second end to end of a lead with both caps should be about 7000ohms).

If all this fails then inspect the Air flow meter connections, inspect the distrubutor rotor and the throttle position switch.

plenty to get you started for now.
Image
User avatar
GAZZANATOR
E30 Zone Newbie
E30 Zone Newbie
Posts: 63
Joined: Sat Nov 28, 2009 11:00 pm
Location: Glasgow,Scotland

Post Fri Dec 02, 2011 9:41 pm

Apologies for shouting,and thanks for the advice.I was speaking to an auto electrician today who suggested the HT leads,so that might be a good place to start.
Failing that I'll work my way through the list and, hopefully,find the problem.