325i jerky under 2k revs

Need technical Q/A then you're in the right place

Moderator: martauto

sweep
Married to the E30 Zone
Married to the E30 Zone
Posts: 10110
Joined: Sat Mar 15, 2008 11:00 pm
Location: spares & repairs in sheffield

Post Mon Nov 28, 2011 9:00 pm

As above any ideas?
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Mon Nov 28, 2011 9:20 pm

Dose it do it when the engine is hot or cold, or all the time.
When used to do this, turned out to be either the TPS switch and/or a leak in the air intake boot. I change both at the same time and that cured the problem
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
HairyScreech
Engaged to the E30 Zone
Engaged to the E30 Zone
Posts: 6265
Joined: Sun Jan 21, 2007 11:00 pm

Post Mon Nov 28, 2011 9:20 pm

on high load and light throttle?
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822

m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
sweep
Married to the E30 Zone
Married to the E30 Zone
Posts: 10110
Joined: Sat Mar 15, 2008 11:00 pm
Location: spares & repairs in sheffield

Post Mon Nov 28, 2011 9:22 pm

warm and cold and more on light throttle
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Mon Nov 28, 2011 10:17 pm

I would start looking around the air intake boot just before the throttle body, look for cracks and splits.
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
User avatar
oracle88
E30 Zone Newbie
E30 Zone Newbie
Posts: 5
Joined: Mon Nov 28, 2011 11:00 pm
Location: mansfield ,notts

Post Tue Nov 29, 2011 5:15 pm

the TPI switch under the inlet manf is usually the fault.on trottling down below 1500 rpm or so, the switch cuts off fuel to early.this problem was known from the first production models of the 325i cab,see the road test in the "motor" mag aug 1986 you can still get this report on "ebay".
adjust the switch if pos or remap (expensive) your ECU,or live with it.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Tue Nov 29, 2011 10:07 pm

TPS needs to be working and correctly adjusted, then elimination of all air leaks on the inlet side and a set of recon. injectors will cure most of these problems.
DmcL
E30 Zone Regular
E30 Zone Regular
Posts: 424
Joined: Thu Mar 12, 2009 11:00 pm
Location: N.Ireland

Post Wed Nov 30, 2011 12:12 am

my money is on the TPS sensor. oil likes to run down the shaft of the TB and into the TPS sensor. my 325i is also doing this, i replaced the original TPS with another and it lasted a couple weeks and was back at it again. i havent adjusted mine or anything since tho so may just need a small adjustment, not high on the priorities list.

what happens is if the TPS doesnt signal the ECU that the throttle is closed the ECU wont switch from part throttle maps back down to idle maps or if theres any transitioning sort of maps from deceleration to idle. theres lots of unknown maps and some look something like decel/back to idle but havent traced for activity in them due to my wonky (again) TPS. ECU ends up idling and running light load/no throttle in the part throttle maps when it should be switching back to idle.

same applies for full throttle. break the connection to the full open side of the TPS and the ECU wont go from part throttle to full throttle maps. toying with the idea of breaking that connection once i turbo my M20 so i can keep the ECU running off a custom large single set of part throttle ignition/fuel maps rather than low part throttle, high part throttle and then full throttle, be much easier to tune if all the activity is happening in a single map as apposed to switching back and forth when tuning.
WMMotorsports