smoking oil
Moderator: martauto
-
retroboyo
- E30 Zone Regular

- Posts: 459
- Joined: Mon Oct 30, 2006 11:00 pm
Once I manage to get the m20b25 running which isnt easy, once the temp gauge gets to the end of the cold blue band the engine cuts out and I cant restart it. If I take the oil filler cap off I can see smoke coming out.
-
gnrsoul
- E30 Zone Regular

- Posts: 612
- Joined: Mon Oct 05, 2009 11:00 pm
- Location: Kincardine Scotland
is there a lot of smoke coming out ??
if the car has been running and is a running temp the smoke could just be the heat
i have seen this on a number of diffrent cars when hot ?
try testing the blue temp senser or maybe also check the thermostat
im sure someone else will have some input in this to hope you getto the bottom of it
if the car has been running and is a running temp the smoke could just be the heat
i have seen this on a number of diffrent cars when hot ?
try testing the blue temp senser or maybe also check the thermostat
im sure someone else will have some input in this to hope you getto the bottom of it
-
retroboyo
- E30 Zone Regular

- Posts: 459
- Joined: Mon Oct 30, 2006 11:00 pm
Thanks gnrsoul, I appreciate the input. I think its heat related. I'm going to try and bleed the coolant more as I have changed the coolant.
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
For Bleeding the best way I have found is:
1. Raise the front end of the car on ramps or axel stands
2. Set the Heater to full for the blower and to full hot
3. Get the car upto just below half way on the guage
4. Open the Bleed Valve on the top of the Thermostat (8mm spanner required)
5. Leave open until you can no longer see air bubles comming out. have a helper keep an eye on the temp guage just incase, dont let it go to red.
6. Top up the coolant.
7. Lower the car.
I have done this the last two times I changed the cooland and it has worked 1st time each time.
1. Raise the front end of the car on ramps or axel stands
2. Set the Heater to full for the blower and to full hot
3. Get the car upto just below half way on the guage
4. Open the Bleed Valve on the top of the Thermostat (8mm spanner required)
5. Leave open until you can no longer see air bubles comming out. have a helper keep an eye on the temp guage just incase, dont let it go to red.
6. Top up the coolant.
7. Lower the car.
I have done this the last two times I changed the cooland and it has worked 1st time each time.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Check that the heater is blowing out warm air as you are warming up the engine. If not, be very careful, as this usually indicates an airlock, which can quickly lead to a cracked head.
For the running fault, measure the resistance from pin 45 of the engine ECU plug (above driver's right knee) to a good body earth, when the engine is cold, and again when the engine is at full temperature.
You'll find it easier to remove the plug if you unbolt the ECU. It can hang on the lead while you warm the car up.
For the running fault, measure the resistance from pin 45 of the engine ECU plug (above driver's right knee) to a good body earth, when the engine is cold, and again when the engine is at full temperature.
You'll find it easier to remove the plug if you unbolt the ECU. It can hang on the lead while you warm the car up.
-
retroboyo
- E30 Zone Regular

- Posts: 459
- Joined: Mon Oct 30, 2006 11:00 pm
Thanks guys, I will give your advice a go
-
HairyScreech
- Engaged to the E30 Zone

- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
is it smoke or is it just condensation steaming off?
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
-
retroboyo
- E30 Zone Regular

- Posts: 459
- Joined: Mon Oct 30, 2006 11:00 pm
This might sound stupid but I'm not sure, it definately wasnt doing it before
