HEADLAMPS WONT TURN OFF
Moderator: martauto
-
wez201178
- E30 Zone Newbie

- Posts: 26
- Joined: Fri Jul 15, 2011 11:00 pm
- Location: market harborough
HELLO ALL,my bloody headlamps on low beam will not go off even with keys out,this only started last night,please help.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Pull out relay K4. If this turns them out, check whether it clicks as you pull it out and push it in.
-
wez201178
- E30 Zone Newbie

- Posts: 26
- Joined: Fri Jul 15, 2011 11:00 pm
- Location: market harborough
Well mate i have to say thankyou very much,took relay out and they went of,put it back in and they stayed of,back to normal,cheers fella.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Open up the relay, and check that deposits haven't built up on the contacts. If so, file them flat with a nail file. Never use sandpaper.
-
HairyScreech
- Engaged to the E30 Zone

- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
why?Brianmoooore wrote:If so, file them flat with a nail file. Never use sandpaper.
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Particles of the grit get embedded in the contacts.
-
HairyScreech
- Engaged to the E30 Zone

- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
yes good point, same reason you have to be careful not to wire brush alu to clean it before welding, if you do then its a stainless brush or bust.
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
-
Barx325i
- Engaged to the E30 Zone

- Posts: 6493
- Joined: Wed Jul 26, 2006 11:00 pm
brass brush on plugs...
