SE/tourigf skirt removal

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
mark_i
E30 Zone Regular
E30 Zone Regular
Posts: 972
Joined: Thu Aug 10, 2006 11:00 pm
Location: Widnes

Post Sun Nov 27, 2011 9:32 pm

any idea how to remove the touring skirts without damaging the clips?

the small front section wont clip off, even though I removed the lower screw. RealOEM shows a plastic grommet and plug similar to the centre fixing of the oil cooler vent.

TIA
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Sun Nov 27, 2011 9:49 pm

There's some push-in clips that just have to be yanked out. Also pay attention to the lip that goes inside the wheel arch; there ought to be two more push-in or even screw-out clips there. If the bottom clip has been removed, then you just need to give it a good tug.
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Mon Nov 28, 2011 6:54 am

The front section is held in place by 2 white push-in plugs.

If you can remove the rear section first this clips into the front section and should enable you to see the plug at the back of the wing IIRC

There is 2 plastic rivets as said above which hold the rear section to the rear arch ( 6mm ) - these usually break so order some more from Ebay

It is easy to break the clips/front section so if you don't have a trim-removal tool use the widest screwdriver you can as close as possible to the fixing to prise the skirt away.
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Mon Nov 28, 2011 9:03 am

All the above assumes that some muppet with a tube of Tigerseal hasn't previously given the car his attention!