Probably a stupid question but is removing the cam cover as easy as removing the mounting bracket for the manifold then the 8 or so nuts holding the cover on?
Got a small oil leak from the cover so think the gasket needs replacing.
Replacing Rocker Cover Gasket
Moderator: martauto
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
-
Ajsingh
- E30 Zone Addict

- Posts: 2378
- Joined: Sun Mar 28, 2010 11:00 pm
- Location: West Laaaandaan init! / Milton Keynes
Its as easy as that mate

E30 Crazy!
-
CHR1S1990
- E30 Zone Camper

- Posts: 1121
- Joined: Fri Mar 14, 2008 11:00 pm
- Location: Blackpool
i'm assuming m20 engine, then it sure is (plus the breather pipe)

-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Replace the D shaped rubber bungs in line with the rocker shafts as well, and make sure the little rocker shaft locating plate at the front of the head is in place properly when you replace the cover.
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Thanks All, sorry yes M20 2.5,
Brian once I order up the gasket and the bungs I'll probably come back to you about the above for help.
Brian once I order up the gasket and the bungs I'll probably come back to you about the above for help.
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
Its v. easy. give the rocker cover a good clean and repaint while it is off. I did and it neatened up the engine bay no end
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Brian, can you help identify the parts for this please. Had a look on realoem but can't find them. Going to order up the gasket and these from cotswolds on Monday
xavier, it will be getting painted also, would like to do the manifold as well but not sure I'm brave \ skilled enough to take it off and put it all back together correctly yet.
Replace the D shaped rubber bungs in line with the rocker shafts as well
xavier, it will be getting painted also, would like to do the manifold as well but not sure I'm brave \ skilled enough to take it off and put it all back together correctly yet.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
#13 on here: http://bmwfans.info/parts/catalog/E30/T ... cam_shaft/
#6 is the locking plate I referred to.
#6 is the locking plate I referred to.
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
Thanks Brian
-
CHR1S1990
- E30 Zone Camper

- Posts: 1121
- Joined: Fri Mar 14, 2008 11:00 pm
- Location: Blackpool
Inlet manifold is very simple too. Im sure there's a guide somewhere but if not, I can get one written.

