cracked head on my 2.5
Moderator: martauto
-
powelly
- E30 Zone Squatter

- Posts: 1649
- Joined: Wed Dec 06, 2006 11:00 pm
- Location: On the scrap heap
I have been a little suspect about this for some time now. My temp gauge has been fluctuating which I thought was the fan, replaced that and it made no difference, the heater plays up too, it will get warm but only when stationary or moving slowly, as soon as you get some speed up it goes cold again, just like It's air locked. Fast forward to yesterday and I was on the way over to mr 13 to cut out an e36 windscreen, sat in traffic the temp gauge started to creep up slowly, it got towards the red so I pulled over and switched off and let the engine cool down, once cooler I re joined the traffic and sure enough the gauge crept up lots of steam from the exhaust too, fortunately the traffic broke and I managed to get some speed up and the gauge came back down. The head gasket has only done about 5000 miles, I reckon the head has cracked, anyone got any thoughts.
Le Mans Classic 2006-
pacerpete
- E30 Zone Team Member

- Posts: 18165
- Joined: Sun Jan 23, 2005 11:00 pm
- Location: Iver heath. South bucks.
4 door + cracked head = China !
Sorry Steve, I couldn't help myself ! You can give me a slap on Thursday and laugh at the compact I have just bought with a bypassed heater matrix
Re the 325, have you done a cooling system pressure test ? any mayo ? any misfiring on a cold start ?
Sorry Steve, I couldn't help myself ! You can give me a slap on Thursday and laugh at the compact I have just bought with a bypassed heater matrix
Re the 325, have you done a cooling system pressure test ? any mayo ? any misfiring on a cold start ?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Heater pipes the correct way around?
Viscous fan coupling in good order?
Viscous fan coupling in good order?
-
clipper
- E30 Zone Squatter

- Posts: 1980
- Joined: Mon Aug 22, 2005 11:00 pm
- Location: Madrid
Surely if you replaced the H/G 5000 miles ago you would have tested the head ?
If it was good then and hasn't overheated since it's unlikely to have cracked since.
If it was good then and hasn't overheated since it's unlikely to have cracked since.
These are sensations as hard to forget as they are to ignore.....
-
powelly
- E30 Zone Squatter

- Posts: 1649
- Joined: Wed Dec 06, 2006 11:00 pm
- Location: On the scrap heap
Viscous is new, the head was tested when I did the gasket, that doesn't mean it couldn't have cracked since. No mayo anywhere and she starts on the button, there was a bit of a misfire after it cooled off yesterday and also a fair bit of steam. I'll just do the usual pressure test and compression test.
I look forward to checking out you new hompact Pete, sounds a real gem.
I look forward to checking out you new hompact Pete, sounds a real gem.
Le Mans Classic 2006-
e30topless
- E30 Zone Team Member

- Posts: 13595
- Joined: Wed Aug 23, 2006 11:00 pm
- Location: surrounded by scrap
hows the stat ? is the top and bottom hose on the rad getting hot ?
-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Using any water?
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
New viscous can be faulty if stored incorrectly.Brianmoooore wrote:Heater pipes the correct way around?
-
powelly
- E30 Zone Squatter

- Posts: 1649
- Joined: Wed Dec 06, 2006 11:00 pm
- Location: On the scrap heap
Right, I'm an idiot, the heater pipes were the wrong way round, this was as a result of fitting the climate heater box, solved that one easily. There is however another issue concerning the fan, a big issue, it's wedged against the rad, how it hasn't chewed through the rad I don't know, that would explain the over heating traffic, looks like new gearbox and engine mounts are on the card, they must have been on their way oh for a while by but I have never noticed any issues in that area.
Le Mans Classic 2006-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Or it can be jammed against the rad!Brianmoooore wrote:New viscous can be faulty if stored incorrectly.Brianmoooore wrote:Heater pipes the correct way around?
As you say, your engine is probably totally detached from the car, just resting on the rubber.
