I read on here,a while back admittedly,that when retro fitting an OBC, it's a good idea to not fit the relay control unit and the wireing to the accessory socket?????
A-would that work? and B-anyone else done that?
The reason for the above method was because it was an un-reliable system,IIRC?
......or should i just stick with the zone wiki method?
OBC retrofit.
Moderator: martauto
-
bss325i
- E30 Zone Team Member

- Posts: 24532
- Joined: Sat Jan 20, 2007 11:00 pm
- Location: London/Surrey
The relay control unit has never given any problems as far as im aware.
Fit the complete set up, anything less is not right especially for your car.
Also, the loom should be clipped into the correct place where the dash loom goes, not just fed though to rattle around behind the dash.
Fit the complete set up, anything less is not right especially for your car.
Also, the loom should be clipped into the correct place where the dash loom goes, not just fed though to rattle around behind the dash.
-
csl
- E30 Zone Addict

- Posts: 2116
- Joined: Mon May 30, 2005 11:00 pm
- Location: Lancaster
Yes its getting clipped to the main dash loom.Am i right in thinking this was originaly done by ordinary "tie wraps"? Or was there some other means,such as proper clips? My unit was already off a car, so not sure.Also, the loom should be clipped into the correct place where the dash loom goes, not just fed though to rattle around behind the dash
-
bss325i
- E30 Zone Team Member

- Posts: 24532
- Joined: Sat Jan 20, 2007 11:00 pm
- Location: London/Surrey
The dash loom is held to the dash with a resuable type of hook strap. Same as the ones which hold the loom to the inner wing in the engine bay.
-
csl
- E30 Zone Addict

- Posts: 2116
- Joined: Mon May 30, 2005 11:00 pm
- Location: Lancaster
Excellent.Thankyou for the info.bss325i wrote:The dash loom is held to the dash with a resuable type of hook strap. Same as the ones which hold the loom to the inner wing in the engine bay.
