Got a problem with my E30 320I SE and was wondering if anyone could shed some light on it.
Basically when I drive my e30 it drives fine, I can drive it hard and rev it high, pulls of fine etc but when I cruise at a constant speed it starts to jerk violently?? it seems to be worse cruising around 55mph but does do it at other speeds. I f I stamp on the throttle when this jerking occurs the car starts to accelerate fine after a brief pause. The idle is a little rough with some minor misfires but nothing major.
If anyone could help that would be great, cheers Nick.
Jerking 320I SE
Moderator: martauto
-
Ajsingh
- E30 Zone Addict

- Posts: 2378
- Joined: Sun Mar 28, 2010 11:00 pm
- Location: West Laaaandaan init! / Milton Keynes
I had this problem on my 320i and it turned out to be the air flow meter. Someone had fiddled with the CO mixture. Put the car on a gas tester and tuned it right and the jerking stopped.
It could also be that your injectors need a clean and are not firing efficently...
Also, under the inlet manifold, there is a wiring loom connector, twist and unhook. This normally clogs up with water and can cause fuelling problems as its the wiring harness to the injectors.. Dry out the water and apply contact grease to prevent happening again
I hope this helps and welcome to the zone btw!
Ajay
It could also be that your injectors need a clean and are not firing efficently...
Also, under the inlet manifold, there is a wiring loom connector, twist and unhook. This normally clogs up with water and can cause fuelling problems as its the wiring harness to the injectors.. Dry out the water and apply contact grease to prevent happening again
I hope this helps and welcome to the zone btw!
Ajay
E30 Crazy!
-
E30BIMMA
- E30 Zone Newbie

- Posts: 2
- Joined: Mon Nov 07, 2011 11:00 pm
Regarding the injector cleaning, could I use some injector cleaner in with the fuel or would it be worth taking them out and inspecting them? will also have a check for that loom connector too see if that helps
thanks for the quick reply and thanks for the welcome too, I haven't introduced myself yet
need to get some pics of the car first, cheers Nick.
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
worth changing the distributor cap, ht leads and rotor arm?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
First thing to do is get the injectors professionally cleaned. See our traders' section.
