cent locking red/black wire mod

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Sun Nov 06, 2011 10:03 pm

something i need to do on my cabby, but i need precise instructions and maybe pictures if possible .. is it just a matter of finding 3 red/black wires going to the door harness, snipp them off and join them together so they dont go to the A pillar connector?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Nov 06, 2011 10:10 pm

Exactly that! Two wires go to the same pin, and the third to another.
Careful that you don't mistake the red/brown for a red/black.
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Sun Nov 06, 2011 11:16 pm

Thanks Brian.. will carry this out as soon as :D
leeparkes
Married to the E30 Zone
Married to the E30 Zone
Posts: 9535
Joined: Thu Jan 03, 2008 11:00 pm
Location: Black country

Post Sun Nov 06, 2011 11:23 pm

What does this red/black wire mod prevent? is there any reason why BMW put them there?

Sorry to highjack. :)
Cypriotgeeza wrote:I done both my mates in my old 318is
felt so proud,even tried it with a E30 325i and got put in my place.. :o:
User avatar
blingsta
Boost Junkie
Posts: 2930
Joined: Fri Jan 27, 2006 11:00 pm
Location: Enfield

Post Sun Nov 06, 2011 11:31 pm

no probs matey.. from what i gather/understand.. these wires are live and they only loop back thru the door connector into the harness... the constant live will cause the corrosion in the pins at the connector !!.. i think ?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Mon Nov 07, 2011 12:07 am

Correct! The corrosion that occurs in the plug/socket is an electrochemical reaction, and removing the permanent live feed removes one of the elements. You can see a similar effect on a car which is fitted with a grey towbar socket, where the permanent live pin is always easily identifiable by the blue/green corrosion on it.
The second most likely pin to corrode in the plug is the ignition live feed to the door mirror and heater element, but since this pin is only live with the ignition on, the effect is much less.
BMW used this arrangement to allow the main car body loom to be manufactured separate to the locking loom, and to provide power for heated door locks when fitted.