rough idle after a few seconds

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
bm_guy
E30 Zone Newbie
E30 Zone Newbie
Posts: 113
Joined: Wed Apr 29, 2009 11:00 pm

Post Sat Nov 05, 2011 3:15 am

As above, i changed my TPS and now I have a rough idle after a few seconds.

Can anyone shed some light on this?
I have checked for air leaks but i cannot find anything.
E30_Crazy
E30 Zone Regular
E30 Zone Regular
Posts: 733
Joined: Fri Mar 05, 2010 11:00 pm
Location: Alaska, USA (Lived in Brandon, Suffolk)

Post Sat Nov 05, 2011 2:15 pm

Try cleaning your ICV. Also try putting a multimeter to the 3 pins on the ICV. IIRC it should be ~20 ohms on either outer pin and the middle one, and ~40 ohms for the two outer pins
User avatar
bm_guy
E30 Zone Newbie
E30 Zone Newbie
Posts: 113
Joined: Wed Apr 29, 2009 11:00 pm

Post Sat Nov 26, 2011 4:44 am

I have cleaned the ICV, check the ICV all seems fine.
Also had the injectors ultrasonically cleaned.
The problem goes away as the car warms up, when up to temperture it runs really sweet especially with the new injectors.
Leads dont have any cracks
What else should i be checking?
mrLEE30
E30 Zone Team Member
E30 Zone Team Member
Posts: 6589
Joined: Tue Jan 18, 2005 11:00 pm
Location: Sweating buckets in Bahrain

Post Sat Nov 26, 2011 6:47 am

Blue temp sensor next to the thermostat. Use the multimeter set to measure ohms. Find the blue temp sensor located toward front of engine near the inlet manifold and where the coolant hose leaves the engine remove the Plug and measure the resistance across the terminals. Should be around 3k when cold and about 250 when hot.
Image
User avatar
bm_guy
E30 Zone Newbie
E30 Zone Newbie
Posts: 113
Joined: Wed Apr 29, 2009 11:00 pm

Post Sat Nov 26, 2011 3:09 pm

Sorry meant to add I have already replaced the temp sensor
E30_Crazy
E30 Zone Regular
E30 Zone Regular
Posts: 733
Joined: Fri Mar 05, 2010 11:00 pm
Location: Alaska, USA (Lived in Brandon, Suffolk)

Post Sat Nov 26, 2011 3:15 pm

It could be bad wiring from the sensor to the ECU. I can't remember which pins they are, but you can check for the same resistance of the sensor at the ECU plug.


EDIT:

Pins 24 and 45 of the ECU plug should read the same as the sensor.