excessive oil inn air box

Need technical Q/A then you're in the right place

Moderator: martauto

320
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Sat Jan 22, 2011 11:00 pm

Post Thu Nov 03, 2011 10:29 pm

Hi all. I have been noticing oil in my air filter. It has gradually got worse over the last month. Now there is quite alot of oil coming from somwhere. I went to bmw and they suggested a few things like a blocked pipe. But have checked and there are no blockages. Any ideas? Thanks[/u]
m_jermyn
E30 Zone Team Member
E30 Zone Team Member
Posts: 4208
Joined: Sat Mar 14, 2009 11:00 pm
Location: Sydney Australia Mate

Post Thu Nov 03, 2011 10:52 pm

Yup

Your piston rings are screwed or there is no cross hatching left on your bores. Result is your piston and rings are not sealing against the bores allowing excessive gasses to enter your crank case.

These gasses mix with oil then travel up the breather tube up inside the head, then they exit the head and run across the engine in the little black pipe that exits your rocker/cam cover and into the throttle body where the cold incoming air entering the throttle body meats with the hot oil vapor air coming out of your engine cooling it and causing the oil vapor to pool. Then that oil runs down your big rubber hose and sits in the air cleaner.


So effectively you have no compression... Leek-down test will confirm this.


Its not a good sign mate.

How old is the car, how many miles ?
320
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Sat Jan 22, 2011 11:00 pm

Post Thu Nov 03, 2011 11:29 pm

Wow thanks for the bad news. Its a 1991 j reg. Its sayin 76,000 on the clock. But i bought ot from london and when i got there the water pump had gone. But i thought it was a bargain so drove it back to birmingham. Topping up the water when needed. Could this have been a contribiting factor to the problem. My bruv has a m52 in his van which i can have if absolutly nessesary. Is there a possible fix ?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Fri Nov 04, 2011 12:10 am

Check that the labyrinth section, on the underside the rocker cover and covered by a steel plate, isn't full of gunge.
320
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Sat Jan 22, 2011 11:00 pm

Post Fri Nov 04, 2011 12:25 am

No. Under the rocker cover is clean no gunge in sight. As ot should be i think.
m_jermyn
E30 Zone Team Member
E30 Zone Team Member
Posts: 4208
Joined: Sat Mar 14, 2009 11:00 pm
Location: Sydney Australia Mate

Post Fri Nov 04, 2011 12:49 am

Unfortunately the only fix is a pull down of the engine give the bores a re hone and chuck a set of rings in it, then there is all the other things you should do when you have it apart.

Pretty costly for a 320 slugger.

Better off getting a 325i m20b25 engine in there for a lot cheaper or use your brothers m52.

The m20 is plug and play the m52 is a tiny bit harder but seems easy enough.
320
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Sat Jan 22, 2011 11:00 pm

Post Fri Nov 04, 2011 7:01 pm

Wpuld my oil pressure light come on if the piston rings have gone. That has never came on.
Jim320i
E30 Zone News / COTM Team
E30 Zone News / COTM Team
Posts: 10627
Joined: Sun Oct 25, 2009 11:00 pm
Location: Leicestershire

Post Fri Nov 04, 2011 7:09 pm

Is this a common fault on the 320i? 8O

Need to check mine over as I had oil in there once, although not sure its still there 8O
320
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Sat Jan 22, 2011 11:00 pm

Post Fri Nov 04, 2011 7:14 pm

Lol. Iv been spending more money on oil than i have on petrol. I had a little accident a few weeks ago and dont know if its worth doing the engine swap and repair work. I think ill ne looking for a 325 mooredoor in the next week or so.
macas
E30 Zone Squatter
E30 Zone Squatter
Posts: 1696
Joined: Sat Mar 10, 2007 11:00 pm
Location: BEAUTIFUL BIRMINGHAM

Post Fri Nov 04, 2011 8:18 pm

Either way tom,yr not having my m52!
320
E30 Zone Regular
E30 Zone Regular
Posts: 251
Joined: Sat Jan 22, 2011 11:00 pm

Post Fri Nov 04, 2011 8:23 pm

Cheers mik. Thanks for the support