320i starting problems .. broken distributor shaft

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
oldfisherman
E30 Zone Newbie
E30 Zone Newbie
Posts: 16
Joined: Thu Sep 01, 2011 11:00 pm
Location: London

Post Wed Oct 26, 2011 3:28 pm

Recently posted that I was experiencing starting problems, no spark etc... finally discovered that the distributor shaft was sheared .... anyone else experienced this? what might cause such a failure?
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Wed Oct 26, 2011 3:36 pm

So you have an early engine with a distributor under the inlet at the front?

Explains why we could not find the CPS.... :D

Cambelt turns a jack shaft,this in turn drives the oil pump and the dizzy.

I would want to be certain that the oil pump is still functioning! :eek:

When you come to swap the cambelt,make sure you find the register mark for the jackshaft,or you will have problems getting the timing correct.
Youth is wasted on the young.
User avatar
oldfisherman
E30 Zone Newbie
E30 Zone Newbie
Posts: 16
Joined: Thu Sep 01, 2011 11:00 pm
Location: London

Post Wed Oct 26, 2011 3:42 pm

Indeed, spent a few fruitless hours searching for something that was not there LoL ... yes good call regards the oil pump... ever heard of this failure before?
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Wed Oct 26, 2011 3:52 pm

oldfisherman wrote:Indeed, spent a few fruitless hours searching for something that was not there LoL ... yes good call regards the oil pump... ever heard of this failure before?
Honestly,no...

But this setup was a 'carry-over' from E21/E28 2 litre units,so those that run the earlier cars may have more information and help.
I'm guessing,but I feel the only way to 'prove' the oil pump is to turn the engine by hand and poke a pinkie down the dizzy hole....something has caused the dizzy to fail,if the oil pump is siezed,is the jack shaft OK? And this.of course leads us to the state of the cambelt....any history indicating when the cambelt was last changed? We advise 30k miles or 3 years,BTW.

With the cambelt off,it should be possible to spin that jackshaft by hand.

Zoner's with good knowledge of this type of early engine include E30topless and E21Jason,a PM may extract some usefull help.
Youth is wasted on the young.
User avatar
oldfisherman
E30 Zone Newbie
E30 Zone Newbie
Posts: 16
Joined: Thu Sep 01, 2011 11:00 pm
Location: London

Post Wed Oct 26, 2011 3:59 pm

Hhhmmm .... one thing always leads to another, fundamental rule of the universe ... cam belt changed only recently ... managed by the previous owner. I have only had the car for 6 weeks or so, and have done maybe 200 miles in it so far... who knows what lurks beneath?