1987 320i no spark need help
Moderator: martauto
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
New to this forum, have an otherwise good 1987 320i stopped in its tracks and will not start, no spark at the plugs, trying to find the CPS, to see if this is the problem, where have they put it? Further, any advise as to what could be causing tye problem would be welcome
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
'87 E30 with a 'proper' engine is right on the 'changeover' between facelift and pre-facelift! Later cars have plastic bumpers,early one's have chrome.
However,you are on the right track.
Early cars have the CPS mounted on the bellhousing,it reads a peg on the flywheel,these pegs are known to fall out...
Later cars have toothed wheel mounted on the front of the crank,read by a sensor mounted just forward of the oil filter,the cable for this one passes behind the fan pulley....
However,you are on the right track.
Early cars have the CPS mounted on the bellhousing,it reads a peg on the flywheel,these pegs are known to fall out...
Later cars have toothed wheel mounted on the front of the crank,read by a sensor mounted just forward of the oil filter,the cable for this one passes behind the fan pulley....
Youth is wasted on the young.
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
OK, I have an early model, chrome bumpers ... not sure what you mean by a proper engine, please explain ... regards this CPS which side left or right top or bottom, have been looking all over the bell housing and cant locate it...
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Proper engine's have 6 cylinders....
I have not owned/played with one of these myself,so cannot help with the location of the sensor,sorry,but it will be there,somewhere!
I would guess that it is exhaust side....
Welcome to the zone,BTW.
I have not owned/played with one of these myself,so cannot help with the location of the sensor,sorry,but it will be there,somewhere!
I would guess that it is exhaust side....
Welcome to the zone,BTW.
Youth is wasted on the young.
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
May thanks, and I appreciate the feedback, yes 6 cyl, not much point otherwise .... Hhhhhmmmm its gotta be there somewhere, problem is the car is moribund in a residential area and I have no way of getting underneath it .... oh man this is really not good....
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Youth is wasted on the young.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Seems daft, but have you taken the HT lead off the coil and connected it straight to a spark plug, bypassing the distributor? Just want to make sure that you've out all the no-spark options first, before you go hunting for the CPS.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
Thanks useful site ... found the part, looks like I expected it to, just have to go and find i now ... many thanks for the help
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
Good idea regards the HT lead,will do as suggested a good diagnostic trick.... thanks
-
clarko74
- Old Skooler

- Posts: 1585
- Joined: Sat Mar 05, 2005 11:00 pm
- Location: Kent
Here they are:

There are two on the underside of the bellhousing (just to the left of the right hand strap).
And here's some info about them:

There are two on the underside of the bellhousing (just to the left of the right hand strap).
And here's some info about them:
HTHAnt wrote:one reads flywheel teeth to give RPM info to the ECU, the other pulses for TDC so the ECU "knows" where the engine is, its this one that uses the TDC keyway that commonly comes adrift
there is a thrid on the mass balancer too but only the Diag socket is connected to that one.
clarko74


-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
That is a really useful pic,and information, big thanks. Just checking the distributor, I dont think this has ever been opened... car is 24 yrs old and only done 46K miles... much to learn ...
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Very nice,stick some photo's up,please!oldfisherman wrote:That is a really useful pic,and information, big thanks. Just checking the distributor, I dont think this has ever been opened... car is 24 yrs old and only done 46K miles... much to learn ...
Youth is wasted on the young.
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
Yar will do, ... right, having finally removed the plastic cover off the distributor, hooked upthe HT lead to a plug, no sparks for sure ... so what next?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
You should check that there is actually 12 volts on the + terminal of the coil, before you get too involved with the more complicated possibilities.
Also, try to establish if the fuel pump runs when you crank the engine. It's probably just in front of the left rear wheel on your car, and you should be able to hear it if you place your ear near to it when someone else cranks the engine.
Also, try to establish if the fuel pump runs when you crank the engine. It's probably just in front of the left rear wheel on your car, and you should be able to hear it if you place your ear near to it when someone else cranks the engine.
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
Have had a good look and feel around my bell housing following the picture .... no such sensors anywhere and no wires to suggest that sensors are in the neighbourhood .... WTF ?
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
Just checked voltage at the + terminal of coil reading 1.7 mV ... what does this indicate?
*quick update*
Just rechecked, the positive terminal of the coil is getting +12.43V when measured against ground, but no voltage drop across the coil. does this indicate that there's a fault in the coil?


*quick update*
Just rechecked, the positive terminal of the coil is getting +12.43V when measured against ground, but no voltage drop across the coil. does this indicate that there's a fault in the coil?
Here you go:daimlerman wrote:Very nice,stick some photo's up,please!


-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
All as it should be.oldfisherman wrote:Just checked voltage at the + terminal of coil reading 1.7 mV ... what does this indicate?
*quick update*
Just rechecked, the positive terminal of the coil is getting +12.43V when measured against ground, but no voltage drop across the coil. does this indicate that there's a fault in the coil?
If you can't find sensors as shown in the pic., you probably have a facelift engine with the sensor on the right hand side of the engine, against the toothed wheel around the crank pulley.
Fuel pump?
-
Andyboy
- Alpina Colada
- Posts: 12577
- Joined: Mon Sep 11, 2006 11:00 pm
- Location: Notts
A 1987 320i with metal bumpers (and no catalyst) will have Bosch LE Jetronic and a distributor at the front of the block under the front of the inlet manifold. The only sensor on the front pulley is for diagnostics and will not stop the engine running.
Lots of possibilities for no spark - shagged rotor arm and cap (I have a pair of mint as-new ones!), buggered king lead, a dodgy old alarm/immobiliser....
There is small matchbox sized control unit down on the inner wing held on with two crosshead screws. The plug connections may be damp/corroded. There are various connections to this. Make sure the brown wire is earthed - run a jumper lead to battery minus in in doubt. The yellow one takes power from the fuel pump relay, the green one and the black one tell the coil to switch.
I would try bridging the contacts in the fuel pump relay - that's on the inner wing near the airbox, possibly under a plastic cover. It has seven pins and you need to remove the outer cover, press the relay contacts together with your fingers and get an assistant to crank the engine. Before doing this, I would remove a fuel pipe from the injector rail and check for fuel delivery - if no fuel, the relay has failed - very common.
Lots of possibilities for no spark - shagged rotor arm and cap (I have a pair of mint as-new ones!), buggered king lead, a dodgy old alarm/immobiliser....
There is small matchbox sized control unit down on the inner wing held on with two crosshead screws. The plug connections may be damp/corroded. There are various connections to this. Make sure the brown wire is earthed - run a jumper lead to battery minus in in doubt. The yellow one takes power from the fuel pump relay, the green one and the black one tell the coil to switch.
I would try bridging the contacts in the fuel pump relay - that's on the inner wing near the airbox, possibly under a plastic cover. It has seven pins and you need to remove the outer cover, press the relay contacts together with your fingers and get an assistant to crank the engine. Before doing this, I would remove a fuel pipe from the injector rail and check for fuel delivery - if no fuel, the relay has failed - very common.
-
TPS
- E30 Zone Team Member

- Posts: 13119
- Joined: Fri Mar 06, 2009 11:00 pm
- Location: Hampshire
Emerald Green?, very nice!oldfisherman wrote: Here you go:

1991 325i Touring Alpine White II
1994 318i Touring Sterling Silver
-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Also check engine earth strap, connected between engine block and chassis rail.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
oldfisherman
- E30 Zone Newbie

- Posts: 16
- Joined: Thu Sep 01, 2011 11:00 pm
- Location: London
Thanks to all for great advise, I am pretty sure it is a failed coil, testing the resistance of primary and secondary coils, suggests that it has failed, just waiting for a replacement ... hope this works...
