Coming to the end of an M20 ITB project and I need to do something about the plenum.
Original plans was to make one out of fibreglass and ive got everything ready, but ive just stumbled across a carbon fibre tube. It holds around 6L of water, but it doesnt look massive at all (I had planned to make one 3L in volume). My question is, I know a lot of stock manifolds are tubular (especially turbod cars) with a throttle on one end, but will a tubular plenum work with ITBs and an 80/70mm flange in the centre of the tube?
Ill get a picture up in a moment if nobody has a clue what im trying to describle. My main worries are:
1. the 6L volume is going to be way too large - do i need to worry about gas velocity/throttle response with such a large plenum when i will have 6 ITBs which are closer to the head?
2: will the tube provide a nice equal gas flow to all 6 runners fed from the centre?
educated thoughts much appreciated
Air Plenum
Moderator: martauto
-
CHR1S1990
- E30 Zone Camper

- Posts: 1121
- Joined: Fri Mar 14, 2008 11:00 pm
- Location: Blackpool
-
CHR1S1990
- E30 Zone Camper

- Posts: 1121
- Joined: Fri Mar 14, 2008 11:00 pm
- Location: Blackpool
wow, this must be a boring topic. perhaps this will liven things up a little:
[youtube][/youtube]
obviously running very lean without the AFM/TPS load signals hence the popping, but that will be sorted tomorrow. decided to make my own plenum rather than use that carbon tube due to space constraints
[youtube][/youtube]
obviously running very lean without the AFM/TPS load signals hence the popping, but that will be sorted tomorrow. decided to make my own plenum rather than use that carbon tube due to space constraints


