S.I.B. Batteries
Moderator: martauto
-
GAZZA3354
- E30 Zone Newbie

- Posts: 58
- Joined: Sun Jul 25, 2010 11:00 pm
Hiya, i changed the batteries on my 89 318i's service indicator board because the the tacho and the mpg gauge havn't worked since i got the car, but they still won't work!. The original batteries did not leak and the board seems undamaged, any ideas please?
-
djsimmy
- E30 Zone Regular

- Posts: 271
- Joined: Sat May 22, 2010 11:00 pm
same as me. pissing me off i need to find a garage that can do it
-
kitch
- E30 Zone Regular

- Posts: 878
- Joined: Sat Nov 01, 2008 11:00 pm
Try the connector to the diff/unit in the diff or the cable coming out of the diff, sometimes the vibrations can cause the cable to become brittle and snap inside the insulation.
-
E30_Crazy
- E30 Zone Regular

- Posts: 733
- Joined: Fri Mar 05, 2010 11:00 pm
- Location: Alaska, USA (Lived in Brandon, Suffolk)
^^^Pretty sure that would only affect the speedo.kitch wrote:Try the connector to the diff/unit in the diff or the cable coming out of the diff, sometimes the vibrations can cause the cable to become brittle and snap inside the insulation.
Are your cars facelifts or pre-facelifts?
-
Barx325i
- Engaged to the E30 Zone

- Posts: 6493
- Joined: Wed Jul 26, 2006 11:00 pm
diff sender is only road speed, however the mpg gauge does need a hand with road speed to work out the miles bit
The rev counter is not related to the diff sender no
The rev counter is not related to the diff sender no
-
E30_Crazy
- E30 Zone Regular

- Posts: 733
- Joined: Fri Mar 05, 2010 11:00 pm
- Location: Alaska, USA (Lived in Brandon, Suffolk)
On pre-facelift looms, it's a white three pin/wire connector under the drivers side dash. Three wires and a plug come out right from the main ECU plug. The other three wires and corrosponding plug come from farther behind the dash and up over the steering column. Check to make sure no wire have come loose from the plugs, and of course that they are plugged into eachother.
If it's a facelift, then the signals along these wires are fed through the C101 plug to the ECU. If you want to check for continuity up to the C101, it's ECU plug pin 6 to C101 pin 9 (RPM) and ECU plug pin 32 to C101 pin 8 (MPG).
Failing that, I would check the sensors for engine speed. I've just converted from pre-facelift to facelift engine/management, so I'm not sure if it's the front toothed pulley or a sensor on the flywheel or something else.
If it's a facelift, then the signals along these wires are fed through the C101 plug to the ECU. If you want to check for continuity up to the C101, it's ECU plug pin 6 to C101 pin 9 (RPM) and ECU plug pin 32 to C101 pin 8 (MPG).
Failing that, I would check the sensors for engine speed. I've just converted from pre-facelift to facelift engine/management, so I'm not sure if it's the front toothed pulley or a sensor on the flywheel or something else.
-
GAZZA3354
- E30 Zone Newbie

- Posts: 58
- Joined: Sun Jul 25, 2010 11:00 pm
Mines a facelift and i'll be checking these items, many thanks for your info
