Stalling at idle

Need technical Q/A then you're in the right place

Moderator: martauto

cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sat Oct 15, 2011 3:16 pm

Occasionally (maybe once or twice a week) the engine stalls when I come to a stop (with the clutch in). What is this likely to be? ICV?

Not sure if it's relevant; but the stalling is so gentle I often don't notice it.
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Sat Oct 15, 2011 3:28 pm

does it only happen when the engine is cold ?

you could have a seized icv or a split intake hose :idea:

what's the rpm on tick over,it might just need turning up a tad
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sat Oct 15, 2011 3:33 pm

magpie wrote:does it only happen when the engine is cold ?

you could have a seized icv or a split intake hose :idea:

what's the rpm on tick over,it might just need turning up a tad
My intake hose was ruined when I went for a Dyno session in March and Rich @ Fritz replaced it with a repaired one and tuned it so I'm thinking that should be okay. Idle is just below 1000 (So maybe aprox 800)

Only happens when engine is warm :mad:
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Sat Oct 15, 2011 4:39 pm

fritz has fooked your car then :idea:
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sat Oct 15, 2011 4:51 pm

Hahaha why's that?
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Sat Oct 15, 2011 5:32 pm

coz it stalls :idea:
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sat Oct 15, 2011 6:34 pm

...

So you don't think it could be an issue with the ICV?
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
turk
E30 Zone Squatter
E30 Zone Squatter
Posts: 1879
Joined: Sun May 20, 2007 11:00 pm
Location: Portsmouth

Post Sat Oct 15, 2011 6:50 pm

Its worth cleaning the icv, but if it been tuned id say the idles either been set too low or the throttle position sensor is duff.
S54, S62, S65 & S85 Plug & Play loom/Ecu Kits
Sump Baffles
Engine Conversion Kits/Parts
TrackDays
Image
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sat Oct 15, 2011 6:53 pm

Well I may be be up that way on Wednesday morning so I'll pop into Fritz if I have time and get it checked.
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sat Oct 15, 2011 6:55 pm

Just for reference, what should it idle at?
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
turk
E30 Zone Squatter
E30 Zone Squatter
Posts: 1879
Joined: Sun May 20, 2007 11:00 pm
Location: Portsmouth

Post Sat Oct 15, 2011 6:56 pm

around 800-850 once hot.
S54, S62, S65 & S85 Plug & Play loom/Ecu Kits
Sump Baffles
Engine Conversion Kits/Parts
TrackDays
Image
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Sat Oct 15, 2011 7:05 pm

7500 is the idle speed without the choke on
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sun Oct 16, 2011 1:32 am

Okay I have a development. Went out for a drive this evening and noticed what the problem is. Idle is fine, however when pulling up to a junction, dipping the clutch as I roll in, the revs drop sharply to around 500, and sometimes drop just below, which seems to cause the stalling.
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Sun Oct 16, 2011 8:31 am

That would suggest a gummed up or knackered Throttle Position Switch as the first culprit.
turk
E30 Zone Squatter
E30 Zone Squatter
Posts: 1879
Joined: Sun May 20, 2007 11:00 pm
Location: Portsmouth

Post Sun Oct 16, 2011 8:37 am

Grrrmachine wrote:That would suggest a gummed up or knackered Throttle Position Switch as the first culprit.
YUP, agree /\
S54, S62, S65 & S85 Plug & Play loom/Ecu Kits
Sump Baffles
Engine Conversion Kits/Parts
TrackDays
Image
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Oct 16, 2011 9:25 am

THERE IS NO ADJUSTMENT FOR IDLE SPEED ON AN E30. DO NOT ADJUST THE THROTTLE STOP, EVER.
The operation of the throttle position switch is the first thing to check, along with the repaired???????????????? air pipe.
e301988325i
E30 Zone Addict
E30 Zone Addict
Posts: 3701
Joined: Fri Feb 01, 2008 11:00 pm
Location: Taunton, Somerset

Post Sun Oct 16, 2011 2:09 pm

Also agree with gungy TPS.

I'd also clean inside your throttle body and the edge of the butterfly's for good measure.
I said:

Can anyone suggest how to test if the boot lights are staying on with the boot shut?

e30topless said:

lock the wife in there
cee
E30 Zone Regular
E30 Zone Regular
Posts: 983
Joined: Sun Aug 23, 2009 11:00 pm
Location: Plymouth

Post Sun Oct 16, 2011 10:30 pm

Okay, thanks guys. project for next weekend then
Image
1990 Sterlingsilber 318iS - 146 bhp / 192 Nm