Loom Question...

Need technical Q/A then you're in the right place

Moderator: martauto

J_A_C_K_Y_D
E30 Zone Newbie
E30 Zone Newbie
Posts: 164
Joined: Fri Sep 10, 2010 11:00 pm
Location: Cardiff

Post Thu Oct 13, 2011 9:29 pm

Hi guys, I'm about half way through my build, I've stripped down my written off 325i, and stripped and rebuilt the new shell I bought! The 1.8 auto is out of the new shell band the 2.5 manual is in :D :D :D

Now my question is, my 325 was an SE and had cruise control, check panal, ABS, OBC, none of which the new shell has... would I do better to completely remove the entire wiring loom out of the old 325 and put it in the new car or try and adapt the loom thats in the 318?

Im okay with the tools, but not too hot on wiring, so which would be the easiest? Ideally I would like all the gadgets that were working on 325 to be in the new car?

Thanks a lot

Elliot
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Fri Oct 14, 2011 1:45 am

Your 325i would have had a check control panel mounted above the mirror,only 4 pot car to be fitted was the M3,easiest way to retro fit is to swap in the entire loom from the 325i...lot of work....the other bits,such as cruise,are sub-looms and can be fitted without too much hassle.
Youth is wasted on the young.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Fri Oct 14, 2011 9:31 am

As above. All the 'gadget' looms, except the 'check' one are essentially separate from the main loom, and can be fitted along side the 318 loom, which will work OK with your 325 engine.
If you want the 'check' panel to work, then you'll have to swap over the complete body loom, which isn't too bad a job on a stripped out car with no engine.

The body loom is attached to the central locking loom by three pins pushed into the socket in the 'A' pillar, for the driver's door loom. These can be removed and transferred, or you can swap the locking loom as well. One of the wires is the infamous 'red/black' that feeds the locking ECU, and I recommend you perform the well documented mod. at the same time.
One minor problem you will come across is the the 325 loom has two horns, in the area above the front brake ducts, rather than the weedy single one behind the grill on four pots.
J_A_C_K_Y_D
E30 Zone Newbie
E30 Zone Newbie
Posts: 164
Joined: Fri Sep 10, 2010 11:00 pm
Location: Cardiff

Post Sat Oct 15, 2011 7:45 pm

Thats brilliant, thanks both!

Pulled the old loom out today, what a job that was! Never thought all those wires would get throught that tiny hole in the bulk head, out now though... just got to try and refit it all now =/

Thanks