Touring-changing rear washer tubing?

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
rover-2000
E30 Zone Newbie
E30 Zone Newbie
Posts: 226
Joined: Thu Aug 25, 2011 11:00 pm
Location: Walsall

Post Wed Oct 12, 2011 3:28 pm

Guys
The tubing to the rear washers on our Touring is leaking. Difficult to be precise where, but it seems to be near the hinge under the headlining. Has anyone changed this tube before? Any tips would be welcome-for instance, how do I drop the rear of the headlining to have a look?
Cheers.
Kind regards
John

1989 320i Touring
1993 E34 525i SE Touring
1979 Porsche 924 Lux
1982 Porsche 924 Lux
1985 Porsche 944 Lux
User avatar
toby
E30 Zone Addict
E30 Zone Addict
Posts: 3609
Joined: Thu Aug 11, 2005 11:00 pm
Location: Kent

Post Wed Oct 12, 2011 6:08 pm

reposted from here;
http://www.e30zone.net/modules.php?name ... ing+washer
Brianmoooore wrote:
toby wrote:Something else I noticed was that there's a special little hole in the pillar to feed the washer tube through and a cable tie next to the hinge to stop the tube kinking and splitting.
Typical BMW attention to detail! Any one that has a kinked pipe, has a pipe that's been refitted incorrectly by somebody.
Unfortunately, the constant bending of the pipe will eventually crack it and you get the en suite shower effect.
Switch the pipe around end to end so that the break is part way up the rear pillar, cut out the damage, and use a joiner to repair the pipe.
Image
User avatar
rover-2000
E30 Zone Newbie
E30 Zone Newbie
Posts: 226
Joined: Thu Aug 25, 2011 11:00 pm
Location: Walsall

Post Wed Oct 12, 2011 6:20 pm

Thanks-that's useful. What I need now though are specifics as to the best way to remove the hose-I can't even see how to remove the rear pillar trims/rear headliner and I don't want to break anything.....
Kind regards
John

1989 320i Touring
1993 E34 525i SE Touring
1979 Porsche 924 Lux
1982 Porsche 924 Lux
1985 Porsche 944 Lux
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Wed Oct 12, 2011 6:29 pm

You don't need to remove any trim other than the plastic that covers the hinge ( just unclips ) - you should then see the hose.

Mine was split right by the hinge so I just trimmed the split part off, pulled a bit more through and re-joined it - job jobbed.

If you need to replace the pipe just tape a piece of string to it, pull it through from the washer bottle end and then just use the string taped to the new pipe to pull the new section through.

:D
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite