drive shaft specification help

Need technical Q/A then you're in the right place

Moderator: martauto

Tedswagon
E30 Zone Addict
E30 Zone Addict
Posts: 2195
Joined: Sun Nov 23, 2008 11:00 pm
Location: Edinburgh

Post Tue Oct 11, 2011 7:51 pm

I'm selling a 3:91 slipper and have been asked the question, can you connect 320 drive shafts to a 3:91 slipper from a 325? I would assume the length is not going to vary but as the power out put is slightly different they might be different.

Any help on this appreciated.
E30 316i auto coupe build thread here viewtopic.php?f=25&t=273035
Rav335uk
E30 Zone Meets/Events Team
E30 Zone Meets/Events Team
Posts: 27978
Joined: Wed Jan 19, 2005 11:00 pm
Location: Mad mad mad

Post Tue Oct 11, 2011 8:25 pm

Should be ok, as the output shafts on a smallcase diff are longer, and vice versa on the largecase.
All I did on mine when i swapped it was unbolt one, and bolt the other up.
Image
If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
e30topless
E30 Zone Team Member
E30 Zone Team Member
Posts: 13595
Joined: Wed Aug 23, 2006 11:00 pm
Location: surrounded by scrap

Post Tue Oct 11, 2011 10:31 pm

yes it will be fine ,
Tedswagon
E30 Zone Addict
E30 Zone Addict
Posts: 2195
Joined: Sun Nov 23, 2008 11:00 pm
Location: Edinburgh

Post Tue Oct 11, 2011 11:22 pm

Cheers for replies.
E30 316i auto coupe build thread here viewtopic.php?f=25&t=273035