tech 1 sport running motronic 1.3 no rev counter

Need technical Q/A then you're in the right place

Moderator: martauto

Alex
Married to the E30 Zone
Married to the E30 Zone
Posts: 22665
Joined: Fri Feb 11, 2005 11:00 pm
Location: Johannesburg, South Africa

Post Mon Oct 10, 2011 1:52 am

Can someone explain in simple terms how to get my rev counter working

its a prefacelift car running the later motronic engine managment, need it sorted as ive possibly sold the car.

i did get a diagram from a zoner emailed to me but i cant open it

thanks

:)
clarko74
Old Skooler
Old Skooler
Posts: 1585
Joined: Sat Mar 05, 2005 11:00 pm
Location: Kent

Post Tue Oct 11, 2011 2:31 pm

It was about a year ago that I did this but I'll give it a go:

You should have a 3 pin (C104) connector exiting your instrument cluster that looks like this:

Image

This is where the pre-facelifts get their tacho and fuel rate signal from, but the facelift ones don't. So you need to cut the corresponding C104 connector from your old engine loom and splice it into the motronic 1.3 loom so the tacho can get it's signal back, connecting the following:
  • Tacho - 0.5mm black on C104 to 0.5mm black from pin 6 JPT55 (ecu plug) connector
  • Fuel Rate - Wht/yel on C104 to Wht/BK on pin 32 of JPT55 (ecu plug) connector
Here's the JPT55 pin layout fyi:

Image

All this is info is taken from this thread: >>clicky<<.

This sounds more tricky than is actually is, I managed it no problem at all and I'm no electrical genius.

HTH
clarko74
Image
Alex
Married to the E30 Zone
Married to the E30 Zone
Posts: 22665
Joined: Fri Feb 11, 2005 11:00 pm
Location: Johannesburg, South Africa

Post Tue Oct 11, 2011 7:36 pm

Excellent Thats what i needed :D
E30_Crazy
E30 Zone Regular
E30 Zone Regular
Posts: 733
Joined: Fri Mar 05, 2010 11:00 pm
Location: Alaska, USA (Lived in Brandon, Suffolk)

Post Tue Oct 11, 2011 10:27 pm

Kind of wondering this myself. Just swapped a facelift engine into a Tech 1. The new loom has a plug there in the same place as the pre-facelift loom. Are these the same wires? If not, do I need to splice the old plug to the wire as mentioned, leaving them to run wherever, or cut them out of the rest of the loom and run straight to the ECU?