odd light

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Sat Sep 24, 2011 9:46 am

My LHS front light blew. I took the globe out which was knackered and put in a new one. But alas it will not work. Anyone know what a likely cause might be, before I spend hours following wires looking for shorts and breaks?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sat Sep 24, 2011 11:27 am

First and most important question is: Was the bulb (globe to you lot) you replaced definitely blown, or just stopped working?
f the bulb was definitely blown, check the fuse very carefully, preferably by substitution, and check out the wiring you disturbed when you changed the bulb, especially the wires where they enter the plug.
User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Sun Sep 25, 2011 5:10 am

Yes the globe was shot. I assumed if it were a fuse, both globes( rear and back) we be out.
User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Sun Sep 25, 2011 9:11 am

Well the fuses all seem good. It looks like a game of find the buggered wire.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Sep 25, 2011 10:21 am

So this is the front parking/side light under discussion here? I'd assumed it was a headlight.
You are right in assuming that the tail light on the same side would also be out if a fuse were blown.
If this is a facelift car, check that the wires on the capless bulb are lying where they should on the glass, and check out the short wire between the bulb holder and the plug on the headlamp frame. I've had a couple of cases where the socket has been crimped onto the insulation of the wire rather than the copper.
User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Tue Sep 27, 2011 12:08 am

Well done Brian. All sorted. You are a gem.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Tue Sep 27, 2011 9:59 am

So what was it exactly?