M20B20 running rough / worse when wet out!

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
mb15
E30 Zone Newbie
E30 Zone Newbie
Posts: 122
Joined: Tue Aug 24, 2010 11:00 pm

Post Fri Sep 16, 2011 1:04 pm

My engine has been stuttering as the revs rise, always worse when under load - like going uphill.

Last few times i've driven the car it has been a damp evening or raining which makes the problem 100 times worse and it struggles to rev at all. It sounds as if it is hitting a rev limiter at any rev range. The revs don't die the needle just stops rising and the car bogs down.

I've changed the rotor arm and the dizzy cap looked clean with no damage or cracks. The plugs were changed last week. The air flow meter has been switched with a known working one and no luck.

I'm thinking the ht leads could be damaged, anyway of checking with out replacements?
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Fri Sep 16, 2011 1:06 pm

Have a look at the crank position sensor,on later cars the lead for this runs behind the waterpump pulley,if the fastening clips fail,guess what happens to the lead?
Youth is wasted on the young.
User avatar
mb15
E30 Zone Newbie
E30 Zone Newbie
Posts: 122
Joined: Tue Aug 24, 2010 11:00 pm

Post Fri Sep 16, 2011 1:11 pm

Yeah i've seen a few threads and this was suggested, i've checked the lead and it looks fine, i cable tied it out of the way of the belt when we changed the water pump. Are the cps expensive for these cars? Might be worth swapping it out anyway.

As with many of the hessitant engine threads, it's really annoying swapping things and finding out it hasn't helpped at all :(
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Fri Sep 16, 2011 1:19 pm

I think the last one I bought was in the area of £15/£20...

H/T leads are unlikely,given the quality of the BMW items,and also very costly to swap on a 'just in case' basis!
Youth is wasted on the young.
User avatar
mb15
E30 Zone Newbie
E30 Zone Newbie
Posts: 122
Joined: Tue Aug 24, 2010 11:00 pm

Post Fri Sep 16, 2011 1:49 pm

Thats not too bad then, i think i'll try a new cps and see where that gets me!

The leads are the standard (BERU) ones and as you say they are in good condition on the outside (no splits or perishing), so that was a long shot really!

Also at idle if you listen to the engine running you can hear the tone change, and then sort itself out again. Would this indicate the crank sensor failing?

Cheers for your input btw! :D
User avatar
mb15
E30 Zone Newbie
E30 Zone Newbie
Posts: 122
Joined: Tue Aug 24, 2010 11:00 pm

Post Fri Nov 04, 2011 10:11 am

Just to finalise this so it might help somebody in future.

It was the dizzy cap causing my hesitation. Looked fine but as soon as it was changed the car runs nice and smooth again. I think the contacts were arcing causing rough running.