Hi guys, im wondering if anyone knows of a way to reduce idle on start up, I know the choke will come in here but with my current exhaust set up it resonates at the 1500 rpm its currently at. Any help?
Cheers
323i idle reduction
Moderator: martauto
-
sweep
- Married to the E30 Zone

- Posts: 10110
- Joined: Sat Mar 15, 2008 11:00 pm
- Location: spares & repairs in sheffield
This has a water controled idle valve which are problemaatic,
-
alexdkj
- E30 Zone Newbie

- Posts: 54
- Joined: Wed Jun 10, 2009 11:00 pm
- Location: Chippenham
Would it be possible to somehow remove the automatic choke???? cause i dont realy need it on start up in this weather! anyone?
-
kyland
- E30 Zone Newbie

- Posts: 14
- Joined: Sun Jun 27, 2010 11:00 pm
- Location: Sydney, Australia
You can adjust the idle from the manifold side of the engine (drivers side on RHD) via the bypass valve...it's the long cylinder attached to the inlet manifold where the vacuum hoses go (for FPR and retard/advance signals). Will try and find a picture for you...hard to describe!
-
kyland
- E30 Zone Newbie

- Posts: 14
- Joined: Sun Jun 27, 2010 11:00 pm
- Location: Sydney, Australia
Here you go...it's no. 5 you're after, and your adjusting no.19. This will reduce/increase idle...but if it continues to be whacky, you will need to replace the air slide valve as mentioned in a n earlier post.


-
Andyboy
- Alpina Colada
- Posts: 12577
- Joined: Mon Sep 11, 2006 11:00 pm
- Location: Notts
They're a bit of a pain these. It can also be down to the ignition being over advanced - you need to check the vacuum advance on manuals and on really early ones (Y/A/B reg), vacuum retard as well. Very often the only way to get the idle down - even when everything seems okay - is to sleeve the air pipe going into the idle valve to reduce the air flow. I had to do this on a 320i which had a new idle valve and everything was as it should be - just could not get it below 1000 rpm.
