Handbrake adjustment

Need technical Q/A then you're in the right place

Moderator: martauto

capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Sun Sep 11, 2011 9:58 pm

Is it just me or are E30 disk brake handbrakes notoriously crap ?

Every one I've had has been poor.

I've spent ages trying to adjust mine today - got newish disks, brand new shoes, new cables, adjusters all lubed and working freely.

I've done it how I understand to be properly - i.e slack the cables right off, adjust the shoes through the hole in the disk until the shoes are binding and then back off a little, then pull the lever on and off a few times, re-check & re adjust etc and then finally take up the slack in the cables.

Result - still crap :x

Do new shoes need to "bed in" ? Do i need to drive it with the handbrake on a little to get some bite into the shoes ?
Will there be stretch in the new cables that I need to keep adjusting out ?

I would expect a decent properly adjusted handbrake to hold the car on a slope within 3-4 clicks. No chance of that with mine at present :roll:


Its driving me mad - and I don't want to put it into the MOT until I know I can get a pass without an advisory for it.

Help !
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Sep 11, 2011 10:43 pm

Handbrake works well enough (although not as good as some other cars) if adjusted properly, using shoes that haven't been worn to odd shapes by incorrect adjustment.
From the car's handbook: "The handbrake.....must be bedded down correctly......the desired effect can be achieved by applying the handbrake lightly at about 25 MPH until definite resistance is felt. Then pull up the lever to the next notch and drive the car about another 400 metres before releasing the handbrake.............Repeat..... at three month in tervals, or whenever the handbrake becomes less effective.
bss325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 24532
Joined: Sat Jan 20, 2007 11:00 pm
Location: London/Surrey

Post Sun Sep 11, 2011 11:29 pm

Did you fit new discs at the same time?

If so did you wipe off the protective film of grease inside the bell of the disc as well at the rotor surface?
http://www.bmrperformance.co.uk

BMW and MINI specialist - Gatwick
capri_rob
Married to the E30 Zone
Married to the E30 Zone
Posts: 9678
Joined: Tue Feb 19, 2008 11:00 pm
Location: South Staffordshire

Post Mon Sep 12, 2011 7:03 am

The disks were carried over from the Bronze turd and had only done about 1000 miles - if that.

The shoes are brand new so are the proper shape.

I think the disks were wiped down with brake cleaner inside & Out prior to initial fitting to the bronzit but can't be sure 8O - it was a couple of Years ago now.

I didn't re-wipe them when the new shoes were fitted anyway but hopefully if there was any contamination that would have gone onto the old handbrake shoes.

I'll try Brians suggestion and report back - thanks for the info guys :thumb:
Image

e30topless said : Proper BMW's have 4 headlights, last of the run was the E30 and E34/E32 anything after that is just complete shite