My e30 is a 1993 325i with switchable auto gearbox,
I want to give the whole car a good service, just wandering if a gearbox service is somthing that i can do my self as a diy job?
I have basic tools and knowledge..
Also if a can do it myself whats the best way to do it?
Whats the best oil to use and are there any filters in the box?
Sorry to be a pain but iv never done it before.
Thanks saj
Auto gearbox service?
Moderator: martauto
-
sajad09
- E30 Zone Regular

- Posts: 671
- Joined: Sun Jan 24, 2010 11:00 pm
- Location: Reading, Berkshire
-
James90
- E30 Zone Regular

- Posts: 271
- Joined: Thu Sep 23, 2010 11:00 pm
- Location: Nottingham
Not had a go at this myself yet but I have the parts ready.
There are 2 gaskets and a filter that you need (and oil obv.!)
Fairly easy to do - I found instructions from a google search.
If you need part numbers I may be able to help you out later - let me know.
From BMW the kit is around £67. I think it is around £14 at ECP but is missing a gasket.
Cheers
There are 2 gaskets and a filter that you need (and oil obv.!)
Fairly easy to do - I found instructions from a google search.
If you need part numbers I may be able to help you out later - let me know.
From BMW the kit is around £67. I think it is around £14 at ECP but is missing a gasket.
Cheers
'88 325i Auto Chromie Cabriolet in Alpine White
-
sajad09
- E30 Zone Regular

- Posts: 671
- Joined: Sun Jan 24, 2010 11:00 pm
- Location: Reading, Berkshire
Cheers. Thanks for the heads up. Will atempt this soon. Will let u know how i get on
-
mrLEE30
- E30 Zone Team Member

- Posts: 6589
- Joined: Tue Jan 18, 2005 11:00 pm
- Location: Sweating buckets in Bahrain
easy to do the job but access is biggest issue, remove the drain pipe from oil pan allow to drain, remove and lower oil pan to drain remainig oil (about 5 litres max) remove the oil pan and clean, using a Torx drive remove the oil filter, replace oil filter and o ring, refit oil pan/fill tube with new gasket. lower car to level and fill, run for a few minutes selecting all gears, check oil level refill if necessary.
.. on a lift or a pit its a half hour job, otherwise take it to a garage....do NOT do it with a jack, at a MINIMUM you should have the front of the car supported on TWO jackstands or less desirable on car ramps.
.. on a lift or a pit its a half hour job, otherwise take it to a garage....do NOT do it with a jack, at a MINIMUM you should have the front of the car supported on TWO jackstands or less desirable on car ramps.

