The bodged bit I think is all to do with the speakers - On the drivers side I have :
From the main loom a grey wire with a yellow stripe and a grey wire with a green stripe - these goes to what I think is the crossover via scotchlock

and then at the other side of the crossover is what would appear to be the main feed from speaker to stereo which is NOT part of the main loom.
However there is what appears to be OEM speaker connections which are unused which are Blue with a red stripe and a larger spade connection and blue with a brown stripe with a smaller spade connection - neither of these were connected to anything.
I removed the tweeter pod which looks factory and has the same Grey/yellow stripe and Grey/Green stripe as described above.
There is also a 3 pin connector where only 2 of the connectors are used with a green/purple stripe wire and a brown/blue stripe wire into it - this plus isnt connected to anything ?
And then visible in the first pic in the thread there is :
single brown/yellow stripe wire with a plastic connector
brown /purple stripe wire with a plastic connector
On the passenger side there appears to have been similar bodgery re the tweeter/crossover/aftermarket main stereo to speaker cable and again what appears to be an unused Factory speaker connector with :
Yellow/red stripe
Yellow/brown stripe
With speaker what look to be speaker connectors.
Think I need to have the stereo out to see if I can find the other ends of these wires
Why the frig can't people install stereos without butchering the factory wiring ??
