Can the rev counter be removed without replacing the whole set of guages.
Can anyone suggest someone who can repair rev counters, mine is jerking up and down rather than a smooth fluid like action.
Rev Counter
Moderator: martauto
-
bpowell555
- E30 Zone Camper

- Posts: 1010
- Joined: Sun Jun 14, 2009 11:00 pm
Same, removing the clocks is easy enough, not sure beyond that. If you can get a spare set then you could take em apart and check for wear? I've also got a random fuel guage so will tighten the brass nut and see if that helps the revs. Can't hurt and so far the tach is only every so often whereas the fuel guage is all the time and a pita,
Cheers
http://www.e30zone.net/modules.php?name ... ove+clocks
Cheers
http://www.e30zone.net/modules.php?name ... ove+clocks
1990 325i touring
She's a minter! Best 3 years of my life - bye bye baby
She's a minter! Best 3 years of my life - bye bye baby
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
All the gauges are easily replaced individually, but bear in mind that the electronics that drive all the gauges, except for the speedo, is all contained on the SI board in the front half of the case.
The needle of the tacho is driven by gears, and a small piece of grit in the teeth can cause this gauge to stick.
The needle of the tacho is driven by gears, and a small piece of grit in the teeth can cause this gauge to stick.
-
beema_boy
- E30 Zone Newbie

- Posts: 236
- Joined: Tue Sep 15, 2009 11:00 pm
Easier to just replace the cluster to be honest. Although it is easy enough to take apart and if your good with electrics then it shouldnt be a problem. Im not the best so once the cluster was apart i tried not to mess too much
Please visit our new store at:
www.phillyskate.co.uk
PM or email for FREE Phillyskate stickers through phillyskatestore@googlemail.com
www.phillyskate.co.uk
PM or email for FREE Phillyskate stickers through phillyskatestore@googlemail.com

