Hi lads I'm replacing a rear door on my touring but would like to swap the original glass across - both the electric window and the quarterlight.
I've been following the bentley manual (chap14 p23), the BMW repair manual (51-342) and various posts on here. I've removed the door card and membrane, lowered the window and removed the two bolts that clamp the glass to the mechanism. I've also removed the inner rubber seal and outer trim piece that sit along the bottom of the window aperture. The next step in the manual says:
4. Swing the front of the window out of the regulator guide
roller and lower the window into the door.
I'm obviously missing something here as my window isn't swinging anywhere. The glass is separated from the winding mechanism, but is still firmly held in position by the guides at either end, so has no lateral movement at all? I can rotate it slightly so the front of the glass lifts, but I don't see how it is going to drop to the floor.
I searched on here but can't find a detailed enough explanation. The following manual steps talk about removing the rubber seal from the front and rear guide tracks, which seems to suggest the glass is no longer in the tracks, then unscrew the quarterlight post and drop it into the door but I can't do this with the window still in place.
Someone help my dumb ass!
rear door glass removal
Moderator: martauto
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Been a while since I did this,but you need to get the rear guide out before the glass will come out,seem to remember that the guide is held by a bolt at it's lower end,then it slides down the seal before it will swing clear.
Think also that having the winding gear as low as possible helps.
Think also that having the winding gear as low as possible helps.
Youth is wasted on the young.
-
Mungo1337
- E30 Zone Newbie

- Posts: 110
- Joined: Sun Apr 04, 2010 11:00 pm
- Location: Derby, UK
thanks daimlerman - seems sensible I'll try that
-
Mungo1337
- E30 Zone Newbie

- Posts: 110
- Joined: Sun Apr 04, 2010 11:00 pm
- Location: Derby, UK
Yay, sorted! Thanks again Daimlerman, undoing the rear guide at the bottom allowed the window to sit in the bottom of the door.
I then had to remove most of the rubber window seal, unscrew the interior door release catch and unclip a guide for the connecting rod and loosen the winding guide to drop the catch down, then remove the two bolts holding the rear quarterlight frame and tug it down into the door. The glass then lifted out.
Removing the quarterlight was a pig but with a lot of wriggling and loosening the seal from the rear of the frame it eventually came out drama free.
I've swapped the doors and now just have to do it all again in the new door, then do it in reverse to refit my original glass
... time for a cup of tea...
I then had to remove most of the rubber window seal, unscrew the interior door release catch and unclip a guide for the connecting rod and loosen the winding guide to drop the catch down, then remove the two bolts holding the rear quarterlight frame and tug it down into the door. The glass then lifted out.
Removing the quarterlight was a pig but with a lot of wriggling and loosening the seal from the rear of the frame it eventually came out drama free.
I've swapped the doors and now just have to do it all again in the new door, then do it in reverse to refit my original glass
Last edited by Mungo1337 on Mon Aug 29, 2011 4:41 pm, edited 2 times in total.
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Practice makes it easier and quicker!
I assume that your original glass has the reg number engraved?
Put the spare glass somewhere safe,you never know when you or another zoner may need it.
I assume that your original glass has the reg number engraved?
Put the spare glass somewhere safe,you never know when you or another zoner may need it.
Youth is wasted on the young.
-
Mungo1337
- E30 Zone Newbie

- Posts: 110
- Joined: Sun Apr 04, 2010 11:00 pm
- Location: Derby, UK
yeh it certainly does make it quicker - second one was apart in 20 mins
Both doors had reg numbers engraved and obviously my homo tendencies meant I had to swap them over
No doubt some mofo will put the glass through in the next week and I'll be doing it all again. Will defo be keeping the glass and anything else that can be retrieved from the old door
No doubt some mofo will put the glass through in the next week and I'll be doing it all again. Will defo be keeping the glass and anything else that can be retrieved from the old door
