new M3 TCA bushes & wishbone = 70mph vibration

Need technical Q/A then you're in the right place

Moderator: martauto

schnaarf
E30 Zone Camper
E30 Zone Camper
Posts: 1076
Joined: Sun Jun 24, 2007 11:00 pm

Post Tue Aug 23, 2011 7:05 pm

Replaced front right wishbone and put M3 eccentric TCA bushes on at the weekend.

General road handing is so much better, feels very precise.

At speeds 60-65 plus I get a shocking vibration through the wheel and floor. No wobble through the dash. I would have expected this points towards wheel balancing or tyres but....

Before replacing the above parts I did 700 miles in a week, mostly on the motorway and vibration trouble free.

Reason for changing arm was a front end knock which has since gone away.

I know the tracking will be out due to M3 bushes but I've adjusted it a little bit which improved steering but made no difference at to the wobble

i also think that that the track rod ball joint (not track rod end) may need replacing. Would this not have caused a vibration before?? Or would this coupled with the tracking being out result in the wobble. The wobble is so bad it actually feels dangerous.

Brakes in a straight line and wobble not made worse under braking.

I think it probably is a bad arm but the fact it felt fine before swapping parts in annoying me

Thanks in advance boys and girls
Last edited by schnaarf on Fri Aug 26, 2011 12:10 pm, edited 1 time in total.
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Wed Aug 24, 2011 1:36 pm

Just removing and replacing the balljoints will have upset them,you did fully tighten the nuts up?

Of course you did,I would suspect the track rod ends first.
Youth is wasted on the young.
schnaarf
E30 Zone Camper
E30 Zone Camper
Posts: 1076
Joined: Sun Jun 24, 2007 11:00 pm

Post Fri Aug 26, 2011 12:06 pm

Thanks, I've got some new rods and ends to fit. They look a bit old and thought it can't hurt to replace them since everything else has been replaced!
daimlerman
**BANNED**
Posts: 15968
Joined: Mon Feb 27, 2006 11:00 pm
Location: Grumpy Old Man

Post Fri Aug 26, 2011 12:31 pm

If you are swapping the entire tie rod,from under the gaiter,you need a bloody big open-ended spanner for the inner nut,27mm IIRC.I took some photo's when I did mine and posted them,but yell if you would like them PMing.
Youth is wasted on the young.