...it's hardly worthy of the technical section and it's quite embarrassing but it's starting to piss me off. Is there some trick to getting the kidneys off the bracket? I've tried for a few minutes but the clips don't want to move and I've given up because I know I'll end up breaking it. I need them off ASAP to paint them. Cheers.
Will.
Edit: 330,000 post in the tech section, I know I'm sad.
A bit of a spastic question...
Moderator: martauto
-
Ranchero
- E30 Zone Addict

- Posts: 2563
- Joined: Thu Sep 17, 2009 11:00 pm
They're not held on by anything- barring rust possibly. Just get a screwdriver and pry 'em off.

-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
Are you talking about the whole unit on the car or just the chrome bits on the grill itself?
-
Willeh
- E30 Zone Newbie

- Posts: 131
- Joined: Sun Sep 26, 2010 11:00 pm
The chrome surrounds from the kidneys, its off the car at the moment.
-
Ranchero
- E30 Zone Addict

- Posts: 2563
- Joined: Thu Sep 17, 2009 11:00 pm
Not sure there's a particular method to this. You just need some patience and some sort of tool to tease the little flaps holding the chrome trim in place forward. Without breaking them of course.
You could try threading piece of wire behind the flap in order to gently pull it forward.
You could try threading piece of wire behind the flap in order to gently pull it forward.

-
polsta
- Married to the E30 Zone

- Posts: 10322
- Joined: Fri Oct 09, 2009 11:00 pm
- Location: portsmouth
i have a spare damaged kidney grill and tried to do this myself and had the same problem and broke a clip or 2 , but once painted you could easily just glue it back on anyway with glue along the inside of the grill parts
-
Jim320i
- E30 Zone News / COTM Team

- Posts: 10627
- Joined: Sun Oct 25, 2009 11:00 pm
- Location: Leicestershire
Generally, when you remove these, the clips almost always snap! I managed to get a set off off though and only broke one so they reattached just fine.
Use a small flat screw driver, expect to swear lots and be ready for it to not go back on... If that is the case, glue it back like suggested. Or buy one already painted black, if thats what your doing.
Use a small flat screw driver, expect to swear lots and be ready for it to not go back on... If that is the case, glue it back like suggested. Or buy one already painted black, if thats what your doing.
-
hongkongfuey
- Mad-tango-geezer
- Posts: 3303
- Joined: Fri Jun 08, 2007 11:00 pm
- Location: portsmouth
submerge the whole lot into hot water(washing up bowl, and prepare to be shouted at by ur missus) small electrical screwdriver, or pick if you have one, when its warm its less likely to break
if there wern't people like me,
with cars like mine,
who would you put down to make yourself feel better?
with cars like mine,
who would you put down to make yourself feel better?
-
adit
- Married to the E30 Zone

- Posts: 13727
- Joined: Wed Jun 20, 2007 11:00 pm
- Location: portsmouth
along with almost all other plastic parts, when forced.Jim320i wrote:Generally, when you remove these, the clips almost always snap!
people seem to forget that 20-25 year old plastic does become somewhat brittle over time.

E30 Parts Galore!! 07901 888019
[quote="bss325i"]
Get a f* grip,we are talking about 20+yr.old sub £10k cars here,NOT the crown jewels!
-
Willeh
- E30 Zone Newbie

- Posts: 131
- Joined: Sun Sep 26, 2010 11:00 pm
Already tried this, helped a bit to make it softer but no luck yet. I want them off to paint them because they were painted before but its was all flaky and shite so I scraped it all off and started again to do a proper job. Think I could get away with them staying on?hongkongfuey wrote:submerge the whole lot into hot water(washing up bowl, and prepare to be shouted at by ur missus) small electrical screwdriver, or pick if you have one, when its warm its less likely to break
