controll arm bush
Moderator: martauto
-
jimbob29
- E30 Zone Regular

- Posts: 266
- Joined: Tue Apr 26, 2011 11:00 pm
- Location: isle of wight
dont no if its me being paranoid but had drivers side bush done about a week ago at local garage and it feels like its worn allready??turned wheels to left to take a look and thers lots of black lumpy grease coming out probably from where mechanic used grease to get bush on the arm can to much grease or wrong grease cause problems?
-
clarko74
- Old Skooler

- Posts: 1585
- Joined: Sat Mar 05, 2005 11:00 pm
- Location: Kent
Grease shouldn't be used on control arm bushes. They should have used either the special lubricant from bmw or washing up liquid which both evaporate and fix the bush to the control arm. Once installed the bush should not be able to rotate on the control arm.
I'd take it back to the garage that did it and tell them to do it properly.
I'd take it back to the garage that did it and tell them to do it properly.
clarko74


-
jimbob29
- E30 Zone Regular

- Posts: 266
- Joined: Tue Apr 26, 2011 11:00 pm
- Location: isle of wight
think heat from exhaust has got rid of most of it lol just called them and they said its must be somthing else and to bring car down.dont think ill be doing that in a hurry!!is ther a way of getting rid of grease without taking it off?presure washer with soapy water or grease remover somthing that doesn't rott the rubber??
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
If the muppet used grease to fit the bush on the control arm pin, then this is the problem!! If it isn't yet, then it soon will be.
THE LUBRICANT USED MUST BE ONE THAT CEASES TO BE A LUBRICANT SHORTLY AFTER THE JOB IS DONE. A 50/50 mix of washing up liquid and water will do, and the car should be dropped back onto the ground immediately afterwards, so that the bush aligns itself on the pin before the lubricant dries.
Take it back to the garage and tell them to do it properly (which incidentally includes changing the one the other side as well!)
You have my permission to print this post off and show it to the garage.
THE LUBRICANT USED MUST BE ONE THAT CEASES TO BE A LUBRICANT SHORTLY AFTER THE JOB IS DONE. A 50/50 mix of washing up liquid and water will do, and the car should be dropped back onto the ground immediately afterwards, so that the bush aligns itself on the pin before the lubricant dries.
Take it back to the garage and tell them to do it properly (which incidentally includes changing the one the other side as well!)
You have my permission to print this post off and show it to the garage.
