Leak from sump area

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
timidtim
E30 Zone Newbie
E30 Zone Newbie
Posts: 27
Joined: Thu Mar 01, 2007 11:00 pm
Location: Essex

Post Mon Aug 15, 2011 7:05 am

I've just noticed a leak has devloped form the the sump/block gasket. (M40). The bolts seemed very loose - less than the 9-11 foot/lb. Do they work loose, and should I try re-torgueing? (How the heck do you spell that!). If not is a new gasket easy to fit?
Image
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Mon Aug 15, 2011 9:00 am

Your M40 has an upper and lower sump, and yes, the bolts do work loose, especially where the upper sump joins the block, and have been known to fall right out. A couple of these bolts are inside the sump, and can only be reached by removing the lower sump. It's quite common to find one or more of these bolts lying in the lower sump!!
You can always try your luck at just tightening everything up, but as above, you'll have to remove the lower sump to do so.
Lower sump is dead easy to remove, and that gives access to the oil pick up pipe, to enable you to remove the upper sump. Far easier to change than on a M20!