Have i missed a connection on the X20 wiring?
I have searched through the wiring diagram and am beginning to feel lost
Its a 540 manual from 94.
If start it with the throttle open its fine, is there a choke of sorts?
TIA
Tom.
Wiring, its starting but not ticking over
Moderator: martauto
Hi i have managed to get the engine to start, but it only runs for a bit,
Have i missed a connection on the X20 wiring?
I have searched through the wiring diagram and am beginning to feel lost
Its a 540 manual from 94.
If start it with the throttle open its fine, is there a choke of sorts?
TIA
Tom.
Have i missed a connection on the X20 wiring?
I have searched through the wiring diagram and am beginning to feel lost
Its a 540 manual from 94.
If start it with the throttle open its fine, is there a choke of sorts?
TIA
Tom.
No.20vt wrote:does it have ews??
I do not have that in the car, will i have to bypass the wire or summit?20vt wrote:cruise control??
if not the only thing left is the idle valve....;)
Where is the idle valve?
-
BaldBimmer
- E30 Zone Newbie
- Posts: 14
- Joined: Wed Oct 25, 2006 11:00 pm
Do you have all your vacume pipes connected? I was trying to run mine the other day after disconneting the brake servo vacume and couldn't work out why it wouldn't tick over. It did run like that but only if I kept revving it.
Other thing is fuel. I spent a while trying to get mine to start then realised I'd done about £15 worth of petrol just having it tickover in the garage!!!! Doh!!!!
Other thing is fuel. I spent a while trying to get mine to start then realised I'd done about £15 worth of petrol just having it tickover in the garage!!!! Doh!!!!
thats an expensive tickover but well worth it for the sound 
Yeah all vaccum pipes are connected, i am getting new lambdas as they may be shot.
It was a vaccum leak! a pipe i missed which a mate found, it sounds the bees, now to make the neighbours happier and make an exhaust 