The old nut is 30mm and the new one is 32mm so i can't use the socket to drive in the locking plate because it's too big.
(anyone know the width of a scaffold pole
? )Locking plate
Moderator: martauto
-
Martinaston
- E30 Zone Addict
- Posts: 3749
- Joined: Mon Mar 14, 2005 11:00 pm
- Location: London
Ive got these to fit at some point and was just wondering if anyone knows how to fit a new locking plate.
The old nut is 30mm and the new one is 32mm so i can't use the socket to drive in the locking plate because it's too big.
(anyone know the width of a scaffold pole ? )
The old nut is 30mm and the new one is 32mm so i can't use the socket to drive in the locking plate because it's too big.
(anyone know the width of a scaffold pole
? )There is NO nucleus.
-
Jamesb318is
- E30 Zone Regular
- Posts: 620
- Joined: Wed Jan 12, 2005 11:00 pm
- Location: East Sussex
the hub nut lock plate? Just push it into place, then hammer with a punch or screwdriver and make sure it splays out round the corners of the nut - job done 
-
Martinaston
- E30 Zone Addict
- Posts: 3749
- Joined: Mon Mar 14, 2005 11:00 pm
- Location: London
cheers james
I just assumed it had to be driven in level with a piece of pipe or something.
I just assumed it had to be driven in level with a piece of pipe or something.
There is NO nucleus.