Hello peeps. Just need a bit of help with my touring. It over heats and pushes the water out of the expansion tank. Either through the overflow pipe or when the cap is off out the cap hole. The car is a E30 320i touring on a G plate. I also get water out of a gasket on the inlet manifold but this only happens when its running. I have changed the thermostat so far and will be cheking the rad early this week. Any help would be very greatfully rieceived.
Thanks
Rich
Over heating touring
Moderator: martauto
-
tourer-dan
- E30 Zone Regular

- Posts: 482
- Joined: Wed May 25, 2005 11:00 pm
- Location: romford, essex
Sorry to break such bad news on your first post, but it sounds like your water system is being over pressurised. Either your water pump has grown a gearbox and is spinning 4 times faster than it should be, or your head gasket or head are likely to be at fault. Could well be a head off job. Take the inlet manifold off first as that might give you a few more clues.
hope it works out!!!
hope it works out!!!
-
Rich25i
- E30 Zone Newbie

- Posts: 187
- Joined: Thu Oct 06, 2005 11:00 pm
- Location: Kent
S**t.
Thanks for the advice
Rich
Thanks for the advice
Rich
-
Andy335Touring
- Married to the E30 Zone

- Posts: 7144
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Long Eaton,Nottingham
Did you bleed the air out if the water level got really low ?
Does your heater make lots of constant hot air ?
Does your heater make lots of constant hot air ?
-
gcorky
- Boost Junkie
- Posts: 2009
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: n.e england
does it cool down whilst driving ,warming up at standstill-bleed-check viscous coupling?
-
Richy325iTouring
- E30 Zone Addict

- Posts: 3490
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Newport SouthWales
if its the head i have a mint 320 head here

-
Rich25i
- E30 Zone Newbie

- Posts: 187
- Joined: Thu Oct 06, 2005 11:00 pm
- Location: Kent
The engine warms up from cold holds on half way for a few min then off it goes into red then big puddle of water by passenger door. It does the same when moving. I have bleed the system using the bleed screws and heater matrix top pipe but still does it.
Hopefully i wil whip head off on fri and check the gasket and head then.
How much for the head if my one has gone?
Hopefully i wil whip head off on fri and check the gasket and head then.
How much for the head if my one has gone?
