Help
Moderator: martauto
-
gazzaD
- E30 Zone Newbie

- Posts: 2
- Joined: Tue Oct 04, 2005 11:00 pm
hi i am new to the site and need a little help i have a e30 318i and for some reson it wont rev above 4500rpm
i changed the fuel pump and it run fine for about ten min and then the fault came back again
-
Sooty
- E30 Zone Camper

- Posts: 1035
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Peterborough
Sounds like it might be a worn cam.
318's are renowned for this problem.
Whip the cover off & inspect the cam lobes closely. It'll be fairly obvious if it's shagged.
Iain S
318's are renowned for this problem.
Whip the cover off & inspect the cam lobes closely. It'll be fairly obvious if it's shagged.
Iain S
-
Martinaston
- E30 Zone Addict

- Posts: 3749
- Joined: Mon Mar 14, 2005 11:00 pm
- Location: London
If the cams worn it will be caused by stiff hydraulic tappets and/or a worn oil pump.
So if you replace the cam, change the tappets as well.
To replace the oil pump is major work and just sa easy to get another engine because the main bearing will be next to go if the pump is shagged.
So if you replace the cam, change the tappets as well.
To replace the oil pump is major work and just sa easy to get another engine because the main bearing will be next to go if the pump is shagged.
There is NO nucleus.
-
eko
- Old timer
- Posts: 11531
- Joined: Sat Feb 05, 2005 11:00 pm
- Location: South Devon
I had a similar problem to this on my old 316i.Changed the air flow meter and the problem dissapeared 

-
gazzaD
- E30 Zone Newbie

- Posts: 2
- Joined: Tue Oct 04, 2005 11:00 pm
thank you for all the info
i was thinking air flow because the engine in the car is a 318i but when i had the car it had a 316i engine in it that was no good
so i changed the engine
i was thinking air flow because the engine in the car is a 318i but when i had the car it had a 316i engine in it that was no good
