325i Head Torque settings

[rare]

Done a bit of a search, but cant seem to find much. Any one of you guys know what the torque setting is on a 325i Head?

(Need to tighten it up)

Cheers

[Adammcf]

Not 100% sure but I think it was 30nm each, then turn all 90 degrees, then 90 degrees again.

[rare]

Cheers Adam:) If any one else out there can back that up then its all go go!

[Jimbob]

i only remember the 90 degree bit twice, not the actual torque. Make sure u get the right combo..

[rare]

Any one else know? 30 sounds a bit low to me, although cheers for the bit about 90 degree's

[craigieeb]

thats right mate, 30nm =22ft pound, then 90degree on all, then another 90 degree,
i have the haynes manuall in pdf form if you want it, it has all the correct settings

[rare]

That would be brilliant craig! rare6499@yahoo.co.uk

[craigieeb]

on route.....................