Can any1 help I.D this connector?

[SCOTT325SE]

Righty then, I just took the under-dash cowling off this morning to replace my ECU and noticed this gem tucked away. The connector I need help identifying is the white and black one in the centre of the shot hanging down.
As you may or may not be able to see, there are 3 cables in the white side. There WERE 2 cables in the black side but they have been cut off.

Does anybody know what these connectors were for and where the cut wires should go to?

Much appriciated if sum1 could shed some light for me.

[Demlotcrew]

The white one is for The AC system when you turn the AC on the ECU raises the revs a little to compensate. Im not 100% sure on the black one.

Andrew

[SCOTT325SE]

so its part of the loom then and i connect the other end if i had AC. nice 1 fella, thank you. that explains the white one.....now for the black one....anybody else know? and does any1 know where it SHOULD be mounted, as mine was just tucked up under the dash

[Demlotcrew]

Its mounted by a white clip to the ECU bracket.

Andrew

[SCOTT325SE]

Cheers buddy. I did have my thoughts that it may have been secured in the same place as ECU due to the size of the hole in it, but wasnt sure, so i thought best to ask.

[Demlotcrew]

Cheers buddy. I did have my thoughts that it may have been secured in the same place as ECU due to the size of the hole in it, but wasnt sure, so i thought best to ask.

You think well scottson

[SCOTT325SE]

wax on, wax off !!!!!

[Brianmoooore]

Isn't the black one used with auto gearboxes? No idea what for, since the only thing I've ever done with autos, is to remove them and replace with manual.

[SCOTT325SE]

no idea mate...i thought i was the one asking the questions?


good call on the auto/manual conversion tho!