1st MOT in 3 years...

[Clarkyboy]

righto, as per the above,

my h plate 318is is heading for its MOT on tuesday, im going to give it a proper going over on friday night and do anything it needs over the weekend,

its been off the road for 3 years, however,

its has,
a new full ss exhaust,
new discs+ pads all round,
new coilovers all round, new wheels and tyres,
new seats and harnesses,
i ran a new earth to the rear lights as it was a little dodgy, all sorted now tho!

I recently stripped it down and did a full respray, so there is no rust inside or out, it needed a little welding (rear inner arch) so that has been done!

so other than what i have already done, where do these usually go wrong?

thanks!!

[Brianmoooore]

Headlamp alignment, rear beam bushes, crusty brake and fuel lines.
Often just running your fingers along the lines can improve their appearance dramatically enough not to attract the attention of a MOT tester.