As i`m using an auto loom on my M50 what do i do about the reverse light switch on the M40 box?
Do i just connect the E30 wire for this or is there something else that i need to do to it?
Cant just try it on this car as it`s a scraper and the rear light loom has been cut off.(it`s all being swapped over to my daily car when it`s all set up and running)
Reverse light switch.
Moderator: martauto
Youre using the M50 and M40 box?
Im pretty sure you use the reverse light wiring from the E30 . Any reverse light wring on the M50 loom isnt needed AFAIK - thats how it was with my S50 conversion anyway.
Im pretty sure you use the reverse light wiring from the E30 . Any reverse light wring on the M50 loom isnt needed AFAIK - thats how it was with my S50 conversion anyway.
James
'91 325i Sport
'93 318i touring 16v
'91 325i Sport
'93 318i touring 16v
Sorry M40 box.
I should of opened my eyes when searching!
http://www.e30zone.net/modules.php?name ... c&t=169175
I should of opened my eyes when searching!
http://www.e30zone.net/modules.php?name ... c&t=169175

You only need to change the plug if you are using a non-E30 gearbox.
So you are using an E30 M40 gearbox? Im interested to know what flywheel/clutch and propshaft you have used
So you are using an E30 M40 gearbox? Im interested to know what flywheel/clutch and propshaft you have used
James
'91 325i Sport
'93 318i touring 16v
'91 325i Sport
'93 318i touring 16v
Wasn`t so much as the plug i wanted to know it was if the E30 one was just a case of connecting it up and bobs your uncle or i had to do a bit of rewiring.
Sounds like it`s just plug and play then.
Yes E30 M40 box.
M20 flywheel with roughly 4.5mm taken off to clear the sump,M20 clutch and a prop from a 320.Tried a 325 one and the front section was too short and the centre bearing didn`t line up with mounting holes.
Sounds like it`s just plug and play then.
Yes E30 M40 box.
M20 flywheel with roughly 4.5mm taken off to clear the sump,M20 clutch and a prop from a 320.Tried a 325 one and the front section was too short and the centre bearing didn`t line up with mounting holes.

Yup, should be plug and play 

Can you guess what my next project is......
Perfect, just what I needed to knowbimanut wrote:
M20 flywheel with roughly 4.5mm taken off to clear the sump,M20 clutch and a prop from a 320.Tried a 325 one and the front section was too short and the centre bearing didn`t line up with mounting holes.
Can you guess what my next project is......
James
'91 325i Sport
'93 318i touring 16v
'91 325i Sport
'93 318i touring 16v


