WONT GO INTO GEAR .. HELP
Moderator: martauto
HI ,,WHEN MY CAR IS COLD IT GOES INTO GEAR PERFECTLY,, BUT WHEN THE ENGINE IS HOT,, ITS HARD WORK TO MAKE IT GO INTO GEAR,, NORMALLY I HAVE TO SELECT 2ND AND THEN FIRST AT THE TRAFFIC LIGHTS,, WHAT DO YOU THINK CAN BE CAUSING THIS PROBLEM,,, ITS NORMALY THE OTHER WAY AROUND,,, HELP
Last edited by buffalino on Thu Jun 10, 2010 12:47 am, edited 1 time in total.
- wullie325i
- CAUTION - unreliable trader!
- Posts: 1398
- Joined: Wed Jul 27, 2005 11:00 pm
fluid issue or maybe the slave cylinder on the gearbox?
- wullie325i
- CAUTION - unreliable trader!
- Posts: 1398
- Joined: Wed Jul 27, 2005 11:00 pm
im not sure mate my first call would be drain the gearbox oil and clutch fluid top up bleed it back up and see where you are.
the slave cylinders go quite regular and start to cause selector problems or completely fail.
other than that its maybe a worn clutch/release bearing or pressure plate issue but i would try my first suggestion as its the easiest
the slave cylinders go quite regular and start to cause selector problems or completely fail.
other than that its maybe a worn clutch/release bearing or pressure plate issue but i would try my first suggestion as its the easiest
- wullie325i
- CAUTION - unreliable trader!
- Posts: 1398
- Joined: Wed Jul 27, 2005 11:00 pm
might not be any oil in the gearbox so its always a good idea to give it some tlc can really bring a box back to life again as so many people over look diff and gearbox fluid.
- wullie325i
- CAUTION - unreliable trader!
- Posts: 1398
- Joined: Wed Jul 27, 2005 11:00 pm
when you try to select a gear and it wont go in does it make any difference if you lift of the clutch then put it back down again?
With it hot raise the car and watch the clutch hose while someone presses the pedal. The hose could be soft and ballooning when hot under pressure. Likewise, bleed the clutch cylinder, and air in there will expand when hot and make things worse.
cheers,
harry
harry
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
With the car safely supported so that you can slide under it,on the o/s of the gearbox is a filler/level plug.Remove this and shove some oil in until it runs out.....
Youth is wasted on the young.
- e30-ryaner
- E30 Zone Newbie

- Posts: 26
- Joined: Sat Oct 31, 2009 11:00 pm
- Location: Dublin, EIRE
sounds like your slave cylinders shot mate



