I did indeed say it used to be a 318i in a former life!
The guy I bought it from was a mechanic so stuck a 2.5 sport engine in
To be fair, the pic is taken from its good side. The nearside front wing has a rust hole in it and rear quarter panel has a dent. The guy also gave me two front wings aswell which only neeed spraying up, then im good to go.
The engine runs fine when warm, but takes a while. I think I need to change the thermostat as it doesn't get up to temperature properly. The driver recaro seat has a hole in it, but my gf has promised to get her sewink kit out. The speedo doesn't work, and after driving it today, I'm pretty sure the rear bearings will need looking at soon.
Apart from that, it stops and goes as it should. As you can see its been lowered about 60mm too.
I never realised how lively the back end was! Been having fun in the snow, I assure you
Im going to leave the car standard for now. No M tec kit as I need to have a proper look at the engine and see what needs doing.
Would be really keen on going to a few meets soon to get some more ideas and also write a few articles as Im studying Automotive journalism.