kami325isport wrote:looks like a top job mate.....what was your guide to build the 2.7?

Built this engine about three years back now,it's run about 40,000 miles so is about run in...
There's a wiki article about it.
Andyboy's book 'E30 Restoration Bible' and zone knowledge helped with the build,my aim was a torquey engine that would give rapid acceleration on the kind of roads that I use everyday.
Living in rural Lincolnshire and commuting via 'C' class roads to work my requirements are quick acceleration for overtaking in minimal distance and decent overall economy,this engine does both.
The only work I have done to it whilst it has been sat on the garage floor has been to swap the 325 cam for a 323 item,and re-build the crankcase breather system.The breather has had a new rubber pipe from rocker cover to T/B,and I failed to fit washers top and bottom to the breather tube between the inlet and the sump,causing loss of oil to some extent.
Other than those two jobs,it's been cleaned and a replacement rocker cover fitted because I trapped the throttle cable in the original,cracking the casting.
The cabbie is really intended as a 'fun,summer' car for my retirement,but it will see a year or two on the home to work commute first!
It will be interesting to see what disernable difference the cam makes,I have a suspision that emmision levels at MoT time will be a challenge,so I have added a lambda sensor as well to help trim the fueling back at steady speed running.
Once I have it tested and running,I intend to have it properly mapped,maybe with a unichip,all advice in this area is welcomed!
Youth is wasted on the young.