'89 Baur 316i - Leaky Shed

Show off your pride and joy here

Moderator: martauto

User avatar
matto
E30 Zone Newbie
E30 Zone Newbie
Posts: 217
Joined: Wed Oct 14, 2009 11:00 pm
Location: Nottingham

Post Fri Oct 23, 2009 2:26 am

Was going to post in the new members section but figured that pictures belong in here.

Bought this cheap and have had it for a week now, did 200 miles or so to bring it home and have done about another 50 since and despite it sounding quite rattly and having some very obvious 'issues' I already love it. My previous daily was a mk1 eunos/mx5 so it feels quite high and heavy but it's all nicely mechanical like the Mazda and unlike more modern cars.

Image

I don't think there's a straight panel on it, but poked and prodded around the arches, sills, footwells and boot there appears to be nothing that is properly rotten! A little surface rust on the both sills, a small patch on the bottom front edge of the nearside rear wing and the edges of the drivers door are rather bubbly.

Image

The previous owner had some odd ideas about tyre sizing too, I've seen bigger tyres on the rear before, but never this way round :)

Image

Go faster stripes!! Gonna have to bodge some temporary fix with these to stop rust and look to replace the bolt on panels.

Image

Mold, fungi, cat hair, oh and duck tape :)

After taking these I went off to the jet wash to give it it's first clean and to see if it was at all waterproof... the drive home while sat in a small swimming pool was uncomfortable and unfamiliar as the mazda was totally leak free. Once it got it home I set to work trying to work out where the main leak was coming from (not the big tear repaired by duck tape surprisingly) turns out it was an errant bolt that had somehow ended up blocking the drain hole right above the driver's head. After that I used silicone lube on all the rubber seals and set to work with my trusty needle, thread and seam sealant and having attacked it with a hose I'm fairly certain it's not going to let in any more water so I just need to grab a bilge pump to get rid of what's currently there :)

Next things on my list are sorting the wheels/tyres, fixing the tilt mech on the drivers seat (and taking the carpet out to dry) and some lowering springs!!
ImysE30
Married to the E30 Zone
Married to the E30 Zone
Posts: 22478
Joined: Mon Jul 07, 2008 11:00 pm
Location: Derby Massive!!

Post Fri Oct 23, 2009 12:13 pm

That's a late baur, should look good with a drop and some TLC 8)
Current Fleet:

E30 335i Turbo M3 Convertible Replica
Z3I
E30 Zone Addict
E30 Zone Addict
Posts: 3504
Joined: Tue Apr 25, 2006 11:00 pm
Location: By Brooklands, in the sunny south.

Post Fri Oct 23, 2009 12:17 pm

Rare beast, some say thankfully, but I think they have understated charm, especially the facelifts.
Selection of BMW hardtops available, please ask!
User avatar
matto
E30 Zone Newbie
E30 Zone Newbie
Posts: 217
Joined: Wed Oct 14, 2009 11:00 pm
Location: Nottingham

Post Fri Oct 23, 2009 5:35 pm

ImysE30 wrote:That's a late baur, should look good with a drop and some TLC 8)
Aye I can only assume that it worked out cheaper to buy one of these with the tiny engine and no extras (not even a stereo judging by the attempt to wire one in) than it was to get a BMW convertible.
ImysE30
Married to the E30 Zone
Married to the E30 Zone
Posts: 22478
Joined: Mon Jul 07, 2008 11:00 pm
Location: Derby Massive!!

Post Fri Oct 23, 2009 9:00 pm

matto wrote:
ImysE30 wrote:That's a late baur, should look good with a drop and some TLC 8)
Aye I can only assume that it worked out cheaper to buy one of these with the tiny engine and no extras (not even a stereo judging by the attempt to wire one in) than it was to get a BMW convertible.
There were only a limited amount of baurs made IIRC, not very popular nowadays, i kinda like 'em though 8)
Current Fleet:

E30 335i Turbo M3 Convertible Replica
Curr946
E30 Zone Regular
E30 Zone Regular
Posts: 425
Joined: Tue Dec 23, 2008 11:00 pm
Location: Inverkeithing Fife

Post Sat Oct 24, 2009 2:52 pm

I personally quite like the baurs, had a giggle seeing the tyres.

My mate had one but some :cens: pinched it, lucky if Ive seen two since.

Good luck restoring her to her former glory.
If your wife must learn to drive, don't stand in her way!
Baurtje
E30 Zone Regular
E30 Zone Regular
Posts: 316
Joined: Thu Dec 28, 2006 11:00 pm
Location: Netherlands

Post Sun Oct 25, 2009 8:22 am

ImysE30 wrote:
matto wrote:
ImysE30 wrote:That's a late baur, should look good with a drop and some TLC 8)
Aye I can only assume that it worked out cheaper to buy one of these with the tiny engine and no extras (not even a stereo judging by the attempt to wire one in) than it was to get a BMW convertible.
There were only a limited amount of baurs made IIRC, not very popular nowadays, i kinda like 'em though 8)
316i RHD Baur's:
Diamantschwarz: 4 pieces
Schwarz: 5

@Matto: can you tell me the Baur-number or 7 last digits of the VIN?
Image

Gr Jeroen
www.Baur-TC.de
BMW 318i 2d '85 Cosmosblau
BMW 325iX Baur TC B47095 '87 Alpinweiss
BMW 325iX Baur TC B47172 '87 Zinnoberred
BMW 320i High Executive 4d '07 Monocablau
whipsey
E30 Zone Addict
E30 Zone Addict
Posts: 3731
Joined: Wed May 25, 2005 11:00 pm
Location: kettering

Post Sun Oct 25, 2009 9:18 am

a cheap temp fix to stop the scratch rusting over winter mate get an old wax candle and rub that over it till you can get it sorted properly it won't look pretty but worked well for mine :thumb:
whipsey
E30 Zone Addict
E30 Zone Addict
Posts: 3731
Joined: Wed May 25, 2005 11:00 pm
Location: kettering

Post Sun Oct 25, 2009 10:13 am

http://cgi.ebay.co.uk/BMW-E30-BAUR-Blac ... 3356c2cc23
just spotted this as well new roof for £100
FMH
E30 Zone Addict
E30 Zone Addict
Posts: 3213
Joined: Tue Jun 02, 2009 11:00 pm
Location: Birmingham

Post Wed Oct 28, 2009 9:09 pm

Will look a lot better with the doors your collecting tomorrow :)
Roof on ebay, bit more tlc, and its looking good
User avatar
matto
E30 Zone Newbie
E30 Zone Newbie
Posts: 217
Joined: Wed Oct 14, 2009 11:00 pm
Location: Nottingham

Post Wed Oct 28, 2009 9:28 pm

Indeed!

I've done a pretty decent job of repairing the roof already using a needle, thread and some clear seam sealant glue, it now appears to be totally waterproof! So the new roof can wait until the summer when I have time to take the old one off and mess around with it for long enough to get the new one fitted without the risk of the british weather filling the car all back up with water :)

The tyres are all the correct sizes now too, which I hope will make a difference to the absurd readings that the speedo gives.

Hmm need to find that baur number for Baurtje...
FMH
E30 Zone Addict
E30 Zone Addict
Posts: 3213
Joined: Tue Jun 02, 2009 11:00 pm
Location: Birmingham

Post Wed Oct 28, 2009 9:30 pm

I read your comment about lowering springs. Do the baurs use same springs as standard e30 or the cabs?
User avatar
matto
E30 Zone Newbie
E30 Zone Newbie
Posts: 217
Joined: Wed Oct 14, 2009 11:00 pm
Location: Nottingham

Post Wed Oct 28, 2009 9:38 pm

Baurtje wrote: @Matto: can you tell me the Baur-number or 7 last digits of the VIN?

Gr Jeroen
B 49388

Although now I look at your piccie the one you show has an extra 2 digits, I'll have another look in better light :)
User avatar
matto
E30 Zone Newbie
E30 Zone Newbie
Posts: 217
Joined: Wed Oct 14, 2009 11:00 pm
Location: Nottingham

Post Wed Oct 28, 2009 9:41 pm

FMH wrote:I read your comment about lowering springs. Do the baurs use same springs as standard e30 or the cabs?
Unfortunately I've not been under the car to check yet, it's parked on the grass outside my house and due to my lack of space I haven't been able to move it anywhere to jack it up and look at the springs. But I'm pretty certain they will just be regular e30 springs as the car is not going to be any heavier than a regular one.