The real deal, 325i Motorsport convertible
Sebring grey
Bubble leather...
Comments welcome..
enjoy











Moderator: martauto














agree..bmw-mad wrote:Looks very nice but would look so much better with some nagaro 15" bbs alloys but its your car



has a problem with the autobox at the moment, getting it converted to manual, put the origional negaro 15" bbs wheels on it..SeymourCake wrote:Nice clean tasty beema. Reminds me of mine but different colour.
Have you got any plans for it?


Shaz325i sport can do the conversions..SeymourCake wrote:How much do you get these conversions done for and from where? As I remember your last one had a manual coversion too. I want it done on mine so I am just enquiring.
Its not far from looking factory as it is now, just the wheels ofcourse.
Also have you got a hardtop? If not I think it would look sweet with one. , colour coded.


I'll pm you how much I paid for it..don-king wrote:nice looking car fella........ what did it set you back if you dont mind me asking, its just I may be in the market for one soon.

PM receivedgoldysingh wrote:I'll pm you how much I paid for it..don-king wrote:nice looking car fella........ what did it set you back if you dont mind me asking, its just I may be in the market for one soon.




Cheers Toby,toby wrote:That's a great looking car.
Shame about the passenger seat. Is the seat base cover still available?
Let me know if you want a leather gear gaiter for the manual conversion.

I agree dump the azevs in the nearest river and get some Nogaro BBSbmw-mad wrote:Looks very nice but would look so much better with some nagaro 15" bbs alloys but its your car




this weekend hopefully...e30topless wrote:I agree dump the azevs in the nearest river and get some Nogaro BBSbmw-mad wrote:Looks very nice but would look so much better with some nagaro 15" bbs alloys but its your car








Brilliant, thanks for that! will get some piant this weekend..mrLEE30 wrote:i nicked your photo above from same angle as mine, into the old photshop and a side by side comparison me thinks i have found the answer!! Sebring grey it is!!
been told the code is 229, so a confimration would be spot on mate!!
as for your car there are a few very simple home jobs you can do that will really tidy it up.
1. look at my guide on fitting tech 2 bumpers
http://www.e30zone.net/e30zonewiki/inde ... ar_bumpers
see the section that explains hoe the lower valance is held on, you need to either refit the valance into the clips, or replace the clips, they cost pence from dealers and will improve the look of the front by a load!!
2. go to Halfords or similar and buy some black rubberised paint - the kind they sell to spray as undersealant on your sills, and some masking tape. then mask all but the bottom 1/4 to 1/2 inch of your tech 2 bumper at the front and spray it black, this will not really be seen and will look loads better then a scratched and chipped lower tech 2 valance - if you can find some grey paint then spray over this too, dont worry about the line as it will certainly apprear better than stone chips!! you can see below i have done the same thing on my cab, if you look real close the bottom half inch is undersealent - now every time i hit the vlalnce it is a five minute job to hide the scratch (in fact getting to this loction i hit a rock and the result is seen just below the left hand side of the centre air vent) but I simply remask it off and spray over it again - 5 mins and gone!!





mrLEE30 wrote:is it a manual or automatic roof??
where is the gap? toward the front where the catches are or at the rear?
If the roof is manual there is a very specific way to fold it down so it is flat, if its electrical/hydraulic then ask DaveD he knows loads about these things![]()
any luck on the paint code?
Ta
Lee


thanks, generally around £500 - £600 inc parts and labourandrew320i wrote:Very nice looking vert! How much does the manual conversions cost?



7.5 x 17" e30 fitmentandrew320i wrote:What size are your azevs?



Not inc parts i don'tRickz wrote:Are you sure?..I think SPADGE does it cheaper then that.
Don't quote me on that though.

How much do you charge including parts then?SPADGE wrote:Not inc parts i don'tRickz wrote:Are you sure?..I think SPADGE does it cheaper then that.
Don't quote me on that though.
